Jonsered LT2220 CMA2 Service and Adjustments, To Remove Mower See Fig, To Install Mower See Fig

Page 22

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

Depress clutch/brake pedal fully and set parking brake.

Place motion control lever in neutral (N) position.

Place attachment clutch in “DISENGAGED” position.

Turn ignition key to “STOP” and remove key.

Make sure the blades and all moving parts have completely stopped.

Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 25)

Mower will be easier to remove from the right side of trac- tor.

Place attachment clutch control in “DISENGAGED” position.

Move attachment lift lever forward to lower mower to its lowest position.

Roll belt off clutch pulley.

Disconnect anti-sway bar from chassis bracket by removing retainer spring.

Disconnect suspension arms from rear deck brackets by removing retainer springs.

Disconnect front links from deck by removing retainer springs.

Raise lift lever to raise suspension arms. Slide mower out from under tractor.

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE MOWER DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINKS.

TO INSTALL MOWER (See Fig. 25)

Be sure tractor is on level surface and mower suspension arms are raised with attachment lift control. Engage park- ing brake.

Slide mower under tractor.

IMPORTANT: Check belt for proper routing in all mower pulley grooves.

Install belt into clutch pulley groove.

Install left front link into the left hand front mower bracket (retain with single loop retainer springs as shown).

Slide right side of mower back and install right front link into right hand front mower bracket (retain with single loop retainer springs).

Place the suspension arms on mower pins, if necessary, rock and raise front of mower to align mower pins with the holes in suspension arms. Retain with double loop retainer spring, loop down as shown.

Connect anti-sway bar to chassis bracket under left footrest and retain with double loop retainer spring.

Raise deck to highest position.

RETAINER

SPRING

SUSPENTION

ARMS

CLUTCH PULLEY

FRONT LINKS

RETAINER SPRING

RETAINER SPRINGS

ANTI SWAY

BAR

Fig. 25

22

Image 22
Contents LT2220 CMA2 General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceIV. Towing Table of Contents Unassembled Parts To Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidInstall Seat See Fig To Install Bagger Components to Tractor See Figs A-4DVertical Adjustment Bagger Adjustment SeeHorizontal Adjustment To Assemble Bagger See Figs A-5CCheck Deck Levelness To Assemble and Install Mulcher Plug See FigCheck Tire Pressure CheckforproperpositionofallbeltsOperation Know Your Tractor HOW to USE Your Tractor To Stop Mower Blades See Fig To Adjust Gauge Wheels See FigTo Operate Mower See Fig Reverse Operation System ROSTo Transport See Fig Service REMINDER/HOUR MeterBefore Starting the Engine Check Engine OIL LevelPurge Transmission To Start Engine See FigAutomatic Transmission Warm UP To Convert Mower See Fig To Dump Bagger See FigBagging See Fig Mowing Tips Mulching Mowing TipsMaintenance Lubrication ChartStar Pattern Blade TractorBlade CARESee Figs.20-22 Check Operator Presence SystemEngine Cleaning To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig To Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Check Brake Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Transaxle Motion Control Lever Neutral Adjustment See FigTo Adjust Steering Wheel Alignment Front Wheel TOE-IN/CAMBERTo Adjust Choke Control Transmission REMOVAL/REPLACEMENTTo Adjust Throttle Control Cable To Adjust CarburetorFuel System StorageOther Engine OILTroubleshooting Points With attachment clutch Service Notes Suggested Guide for Sighting Slopes for Safe Operation Jonsered Motor AB