IPSO T45, T30 installation manual Gas Connection Locations, Models Gas Connection

Page 8

Tumblers – T30 and T45

Gas Connection Locations

C

1	B
	A

11/2 in. NPT

TMB1970N

TMB1970N

	Models			Gas Connection
	Models		A	B	C
			A	B	C
		Non-CE and	75.20 in.	1.74 in.	36.84 in.
T30		Non-Australian	(1910 mm)	(44 mm)	(936 mm)

		CE and	75.28 in.	2.5 in.	30.60 in.
		CE and	75.28 in.	2.5 in.	30.60 in.
		Australian	(1912 mm)	(64 mm)	(777 mm)
		T45	78.75 in.	4.12 in.	42.88 in.
		T45	(2000 mm)	(105 mm)	(1089 mm)
			(2000 mm)	(105 mm)	(1089 mm)

7

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

4-08-43

Image 8

Contents On-Premise Laundry Planning Handbook Contents Introduction Model IdentificationTumblers T30 and T45 Conversion Table Multiply To ObtainSteam Coil Rating at 100 psig Boiler Horsepower Btu/hr Pounds kgCylinder Size Inches mmCabinet Dimensions Models T30Exhaust Outlet Locations Models Rear ExhaustGas Connection Locations Models Gas ConnectionElectrical Connection Locations Steam Connection Locations Models Inlet Outlet T30Upper LowerInstallation Pre-Installation InspectionW056R1 TMB2110N Exhaust Requirements LayoutMake-Up Air VentingIndividual Venting Duct Equivalent Length of Rigid Diameter Straight DuctManifold Venting T438I Duct T30 T45 Mm DuctDuct T30 T45 Station Mm Duct TWO Manifold AssembliesElectrical Requirements for Gas and Steam Models Terminal Block Recommended Fuse CurrentMinimum Connections Amps Or Breaker Rating Poles Conductor SizeElectrical Requirements for Electric Models Terminal Block RecommendedCurrent Breaker Minimum Connections Amps Poles Conductor Size Required