Guardian Technologies 004702-0, 004703-0, 004704-0, 004705-0, 004706-0, 004707-0 owner manual

Page 37

Section 7 – Post Installation

Recreational Vehicle Generators

7.4TESTING UNDER LOAD

Apply electrical loads equal to about 75 to 100 per- cent of the unit's rated wattage/amperage capacity.

Let the unit run at least 30 minutes with load applied. During this part of the test, check that the unit is not running excessively hot and that adequate cooling airflow is available. Do not allow the unit to overheat during prolonged operation.

NOTE:

The generator engine is equipped with a high tem- perature switch. The switch has normally open (N.O.) contacts. When the engine temperature is too high, switch contacts close, and the engine shuts down automatically.

THE MANUFACTURER RECOMMENDS THAT THE GENERATOR BE TESTED FOR ADEQUATE COOL- ING.

7.5INSTALLATION CHECKLIST

‹LOCATION AND SUPPORT

❑Generator is properly located.

❑Generator is properly supported.

❑Generator is properly restrained.

‹OPTIONAL LP GAS FUEL SYSTEM

❑Fuel system is properly installed and checked for leaks.

❑Pressure at regulator inlet is correct.

❑Rated flow of primary regulator is correct.

❑All parts are properly installed.

❑Fuel system is properly tested/adjusted.

‹EXHAUST SYSTEM

❑Exhaust system complies with all applicable codes.

❑Exhaust system is properly and safely installed.

‹ELECTRICAL CONNECTIONS

❑Connections comply with local code requirements and all National Electrical Codes.

❑Junction box is properly installed.

❑Wiring meets all standards.

❑All connections are correct.

❑Conduit is properly installed and sealed.

❑Generator is properly bonded to the vehicle.

‹GENERATOR COMPARTMENT

❑Compartment construction is proper.

❑Holes/Openings are vapor-sealed.

❑Compartment size is correct.

❑Compartment is vapor-sealed.

❑Sound insulation is correct.

❑Floor cutouts are properly completed.

‹BATTERY INSTALLATION

❑Recommended battery is installed.

❑Recommended cables are installed.

❑Cables are clean and tight.

❑Cables are connected properly.

❑Proper ventilation is provided.

❑Terminals are coated with anti-corrosion grease, and terminal covers are positioned.

‹COOLING AND VENTILATING AIR

❑Airflow is adequate.

❑Air inlet opening is correct.

❑Compensate for restrictions.

❑Check that installation has been tested.

‹GASOLINE FUEL SYSTEM

❑Fuel tank complies with all applicable codes.

❑Fuel system is properly installed and checked for leaks.

‹OPTIONAL ACCESSORIES

❑Check that remote start/stop panels (if used) are installed properly.

❑Check that hourmeter kit (if used) is installed properly.

❑Check that any other options and accessories (if used) are installed properly.

‹POST INSTALLATION TESTS

❑Check that all tests are completed properly.

DATE OF INSTALLATION ____________________________________________________

NAME OF INSTALLER_______________________________________________________

SIGNATURE OF INSTALLER _________________________________________________

35

Page 36 Page 38
Image 37
Page 36 Page 38
Contents This manual should remain with the unit ‹ Operation and Maintenance ‹ Contents‹ HOW to Obtain Service IntroductionPart I Operating Instructions Part II Installation Instructions Warning   Electrical Hazards   Reference Number Identification Generator IdentificationSafety InstallationGenerator Applicability Generator AC Connection System‹ 1.6.3 Engine Specifications Specifications‹ 1.6.2 Engine OIL Requirements ‹ 1.6.1 Fuel Requirements GasolineGenerator Control Panel ‹ 2.1.2 START/STOP Switch‹ 1.6.5 Emissions Compliance Period ‹ 2.1.1 Fuel PrimerBefore Starting the Engine Optional Remote START/STOP PanelAutomatic Choke Stopping the Generator Starting the Generator‹ 2.7.1 Letting the Engine Stabilize ‹ 2.8.2 High Temperature Switch ‹ 2.8.1 LOW OIL Pressure SwitchProtection Systems ‹ 2.7.2 do not Overload the Generator‹ 2.8.4 Overvoltage Protection Checking the Engine OIL Level‹ 2.8.6 25-HOUR CHECK-UP ‹ 2.8.5 25-HOUR BREAK-IN Period‹ 3.3.1 Cleaning the Foam Precleaner Maintaining the Engine AIR CleanerChanging the Engine OIL AND/OR OIL Filter Checking the Engine Spark Plug Clean Spark ArrestorBattery Maintenance Cleaning the Generator‹ 3.8.1 Weekly ‹ 3.8.2 Every SIX MonthsRV Generator Service Interval OUT of Service ProcedureDrive Belt Exercising the GeneratorRecreational Vehicle Generators Part  General Hazards   Electrical Hazards  Standards Booklets Purpose and Scope Installation InstructionsEquipment Description Generator Engine Operating SpeedMajor Features ‹ 6.1.2 Generator Support Location and Support‹ 6.1.1 Generator Location ‹ 6.1.3 Suspended Mounting Generator Compartments‹ 6.2.1 Compartment Size ‹ 6.1.4 Generator RestraintTypical Compartment Construction ‹ 6.2.3 Sound Insulating Materials‹ 6.2.4 Acoustics Cooling and Ventilating AIR‹ 6.2.5 Compartment Floor Cutouts ‹ 6.3.1 Generator AirflowGasoline Fuel System ‹ 6.3.2 Testing the Installation‹ 6.4.2 Generator Fuel Supply Line LP GAS Fuel System‹ 6.5.1 LP Fuel Consumption LB./HOUR ‹ 6.5.4 Vapor Withdrawal ‹ 6.5.2 Parts not Included in Fuel System‹ 6.5.5 Primary Regulator ‹ 6.5.3 Some Important Considerations‹ 6.5.7 Fuel Supply Lines Exhaust System‹ 6.5.9 Leakage Tests Electrical Connections ‹ 6.6.2 Exhaust System Safety‹ 6.6.1 Mufflers and Spark Arrestors ‹ 6.7.5 Isolating Different Power Sources ‹ 6.7.2 Wiring‹ 6.7.1 Electrical Junction BOX ‹ 6.7.3 Generator AC ConnectionsBattery Installation 15 Transfer Switch Isolation Method Post Installation Tests Optional AccessoriesBefore Initial START-UP Initial StartInstallation Checklist Testing Under LoadProblem Cause Correction Troubleshooting GuideRecreational Vehicle Generators Battery Voltage 19 18 Part NO. QTY Description View a QTY 113 Screw Hhtt M6-1.0 X 16 YC 28,2 Circuit Breaker 3 X 15A 15B 3938 ASSEMBLY, Crankcase RV Exploded Views and Parts Lists CASTING, Twin Regulator Housing MANUFACTURER’S Emission Control System Warranty Coverage Your Warranty Rights and ObligationsPURCHASER’S/OWNER’S Warranty Responsibilities Emission Related Parts Include the Following Emission Control System WarrantyWarranty Schedule Commercial Applications

004702-0, 004703-0, 004704-0, 004705-0, 004706-0, 004707-0 specifications

Guardian Technologies has established itself as a prominent leader in the realm of air purification with its innovative product line, specifically the models 004702-0, 004703-0, 004704-0, 004705-0, 004706-0, and 004707-0. Each model combines cutting-edge technology with user-friendly features to ensure a cleaner and healthier indoor environment.

One of the standout features across these models is the use of True HEPA filtration. This technology efficiently captures 99.97% of airborne particles as small as 0.3 microns, including dust, pollen, pet dander, and smoke. This is essential for individuals with allergies or respiratory issues, providing peace of mind through cleaner air.

In addition to the HEPA filters, Guardian Technologies incorporates activated carbon filters in these models. This feature helps reduce unwanted odors from pets, cooking, and household chemicals, making the air in your home more pleasant. The combination of HEPA and activated carbon makes these models effective for comprehensive air purification.

These models also integrate smart technology, offering user-friendly controls that simplify operation. Many units are equipped with filter change indicators, ensuring users are alerted when it’s time to replace the filters. This promotes optimal air quality and prolongs the efficiency of the machines.

The Guardian Technologies models have a compact and modern design, allowing them to fit seamlessly into any home or office decor. Their lightweight design facilitates easy mobility, enabling users to place them in various locations as needed.

Energy efficiency is another significant characteristic featured in these air purifiers. Many of the models are ENERGY STAR certified, which means they meet strict energy efficiency guidelines set by the U.S. Environmental Protection Agency. This not only helps reduce electricity costs but also makes these purifiers an environmentally friendly choice.

Noise levels are kept to a minimum with these units, ensuring they operate quietly without disrupting daily activities such as work, sleep, or family time. This is particularly important in shared living spaces, where background noise can be a concern.

Overall, Guardian Technologies presents an impressive lineup of air purifiers through models 004702-0, 004703-0, 004704-0, 004705-0, 004706-0, and 004707-0. Their combination of advanced filtration, smart technology, energy efficiency, and stylish design positions them as excellent options for anyone looking to improve their indoor air quality. Whether in a home or office, these models contribute significantly to a healthier living environment, making them a worthy investment for consumers seeking enhanced air purification solutions.
Top Page Image Contents