Guardian Technologies 004702-0, 004703-0, 004704-0, 004705-0, 004706-0, 004707-0 owner manual

Page 55

Section 12 – Warranty

Recreational Vehicle Generators

EMISSION CONTROL SYSTEM WARRANTY

Emission Control System Warranty (ECS Warranty) for 1997 and later model year engines:

(a)Applicability: This warranty shall apply to 1997 and later model year engines. The ECS Warranty Period shall begin on the date the new engine or equipment is purchased by/delivered to its original, end-use purchaser/owner and shall continue for 24 consecutive months thereafter.

(b)General Emissions Warranty Coverage: Generac warrants to the original, end-use purchaser/owner of the new engine or equipment, and to each subsequent purchaser/owner, that each of its engines is ...

(1)Designed, built and equipped so as to conform with all applicable regulations adopted by the EPA and CARB pursuant to their respective authority, and

(2)Free from defects in materials and workmanship which, at any time during the ECS Warranty Period, may cause a warranted emissions-related part to fail to be identical in all material respects to the part as described in the engine manufacturer’s application for certification.

(c)The ECS Warranty only pertains to emissions-related parts on your engine, as follows:

(1)Any warranted, emissions-related parts that are not scheduled for replacement as required maintenance in the Owner’s Manual shall be warranted for the ECS Warranty Period. If any such part fails during the ECS Warranty Period, it shall be repaired or replaced by Generac according to Subsection (4) below. Any such part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period.

(2)Any warranted, emissions-related part that is scheduled only for regular inspection as specified in the Owner’s Manual shall be warranted for the ECS Warranty Period. A statement in such written instructions to the effect of “repair or replace as necessary” shall not reduce the ECS Warranty Period. Any such part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period.

(3)Any warranted, emissions-related part that is scheduled for replacement as required maintenance in the Owner’s Manual shall be warranted for the period of time prior to the first scheduled replacement point for that part. If the part fails prior to the first scheduled replacement, the part shall be repaired or replaced by Generac according to Subsection

(4)below. Any such emissions-related part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period prior to the first scheduled replacement point for such emissions-related part.

(4)Repair or replacement of any warranted, emissions-related part under this ECS Warranty shall be performed at no charge to the owner at a Generac Authorized Warranty Service Facility.

(5)When the engine is inspected by a Generac Authorized Warranty Service Facility, the owner shall not be held responsible for diagnostic costs if the repair is deemed warrantable.

(6)Generac shall be liable for damages to other original engine components or approved modifications proximately caused by a failure under warranty of any emission-related part covered by the ECS Warranty.

(7)Throughout the ECS Warranty Period, Generac shall maintain a supply of warranted emission-related parts sufficient to meet the expected demand for such emission-related parts.

(8)Any Generac authorized and approved emission-related replacement part may be used in the performance of any ECS Warranty maintenance or repairs and will be provided without charge to the purchaser/owner. Such use shall not reduce Generac’s ECS Warranty obligations.

(9)Unapproved, add-on, modified, counterfeit and/or ‘grey market’ parts may not be used to modify or repair a Generac engine. Such use voids this ECS Warranty and shall be sufficient grounds for disallowing an ECS Warranty claim. Generac shall not be held liable hereunder for failures of any warranted parts of a Generac engine caused by the use of such an unapproved, add-on, modified, counterfeit and/or ‘grey market’ part.

EMISSION RELATED PARTS INCLUDE THE FOLLOWING:

1) Fuel Metering System:

2)

Air Induction System including:

1.1) Gasoline carburetor assembly and its

a) Intake pipe/manifold

internal components (if so equipped).

b) Air cleaner

a) Fuel filter (if so equipped)

3)

Ignition System including:

b) Carburetor gaskets

a) Spark plug

c) Fuel pump (if so equipped)

b) Ignition module

1.2) LPG carburetion assembly and its

4) Catalytic Muffler Assembly (if so equipped) including:

internal components (if so equipped).

a) Muffler gasket

a) Fuel controller (if so equipped)

b) Exhaust manifold

b) Mixer and its gaskets (if so equipped)

5)

Crankcase Breather Assembly including:

c) Carburetor and its gaskets (if so equipped)

a) Breather connection tube

d) Primary gas regulator (if so equipped)

 

 

e) LP liquid vaporizer (if so equipped)

*Generac engine types covered by this warranty statement include the following:

1)Utility

2)Lawn and Garden Equipment

3)Recreational Vehicle (RV) Generator

4)Industrial Mobile (IM) Generator

Part 2

53

Page 54 Page 56
Image 55
Page 54 Page 56
Contents This manual should remain with the unit Introduction ‹ Contents‹ Operation and Maintenance ‹ HOW to Obtain ServicePart I Operating Instructions Part II Installation Instructions Warning   Electrical Hazards   Reference Number Identification Generator IdentificationGenerator AC Connection System InstallationSafety Generator Applicability‹ 1.6.1 Fuel Requirements Gasoline Specifications‹ 1.6.3 Engine Specifications ‹ 1.6.2 Engine OIL Requirements‹ 2.1.1 Fuel Primer ‹ 2.1.2 START/STOP SwitchGenerator Control Panel ‹ 1.6.5 Emissions Compliance PeriodBefore Starting the Engine Optional Remote START/STOP PanelAutomatic Choke Stopping the Generator Starting the Generator‹ 2.7.1 Letting the Engine Stabilize ‹ 2.7.2 do not Overload the Generator ‹ 2.8.1 LOW OIL Pressure Switch‹ 2.8.2 High Temperature Switch Protection Systems‹ 2.8.5 25-HOUR BREAK-IN Period Checking the Engine OIL Level‹ 2.8.4 Overvoltage Protection ‹ 2.8.6 25-HOUR CHECK-UP‹ 3.3.1 Cleaning the Foam Precleaner Maintaining the Engine AIR CleanerChanging the Engine OIL AND/OR OIL Filter Checking the Engine Spark Plug Clean Spark Arrestor‹ 3.8.2 Every SIX Months Cleaning the GeneratorBattery Maintenance ‹ 3.8.1 WeeklyExercising the Generator OUT of Service ProcedureRV Generator Service Interval Drive BeltRecreational Vehicle Generators Part  General Hazards   Electrical Hazards  Generator Engine Operating Speed Purpose and Scope Installation InstructionsStandards Booklets Equipment DescriptionMajor Features ‹ 6.1.2 Generator Support Location and Support‹ 6.1.1 Generator Location ‹ 6.1.4 Generator Restraint Generator Compartments‹ 6.1.3 Suspended Mounting ‹ 6.2.1 Compartment SizeTypical Compartment Construction ‹ 6.2.3 Sound Insulating Materials‹ 6.3.1 Generator Airflow Cooling and Ventilating AIR‹ 6.2.4 Acoustics ‹ 6.2.5 Compartment Floor CutoutsGasoline Fuel System ‹ 6.3.2 Testing the Installation‹ 6.4.2 Generator Fuel Supply Line LP GAS Fuel System‹ 6.5.1 LP Fuel Consumption LB./HOUR ‹ 6.5.3 Some Important Considerations ‹ 6.5.2 Parts not Included in Fuel System‹ 6.5.4 Vapor Withdrawal ‹ 6.5.5 Primary Regulator‹ 6.5.7 Fuel Supply Lines Exhaust System‹ 6.5.9 Leakage Tests Electrical Connections ‹ 6.6.2 Exhaust System Safety‹ 6.6.1 Mufflers and Spark Arrestors ‹ 6.7.3 Generator AC Connections ‹ 6.7.2 Wiring‹ 6.7.5 Isolating Different Power Sources ‹ 6.7.1 Electrical Junction BOXBattery Installation 15 Transfer Switch Isolation Method Initial Start Optional AccessoriesPost Installation Tests Before Initial START-UPInstallation Checklist Testing Under LoadProblem Cause Correction Troubleshooting GuideRecreational Vehicle Generators Battery Voltage 19 18 Part NO. QTY Description View a QTY 113 Screw Hhtt M6-1.0 X 16 YC 28,2 Circuit Breaker 3 X 15A 15B 3938 ASSEMBLY, Crankcase RV Exploded Views and Parts Lists CASTING, Twin Regulator Housing MANUFACTURER’S Emission Control System Warranty Coverage Your Warranty Rights and ObligationsPURCHASER’S/OWNER’S Warranty Responsibilities Emission Related Parts Include the Following Emission Control System WarrantyWarranty Schedule Commercial Applications

004702-0, 004703-0, 004704-0, 004705-0, 004706-0, 004707-0 specifications

Guardian Technologies has established itself as a prominent leader in the realm of air purification with its innovative product line, specifically the models 004702-0, 004703-0, 004704-0, 004705-0, 004706-0, and 004707-0. Each model combines cutting-edge technology with user-friendly features to ensure a cleaner and healthier indoor environment.

One of the standout features across these models is the use of True HEPA filtration. This technology efficiently captures 99.97% of airborne particles as small as 0.3 microns, including dust, pollen, pet dander, and smoke. This is essential for individuals with allergies or respiratory issues, providing peace of mind through cleaner air.

In addition to the HEPA filters, Guardian Technologies incorporates activated carbon filters in these models. This feature helps reduce unwanted odors from pets, cooking, and household chemicals, making the air in your home more pleasant. The combination of HEPA and activated carbon makes these models effective for comprehensive air purification.

These models also integrate smart technology, offering user-friendly controls that simplify operation. Many units are equipped with filter change indicators, ensuring users are alerted when it’s time to replace the filters. This promotes optimal air quality and prolongs the efficiency of the machines.

The Guardian Technologies models have a compact and modern design, allowing them to fit seamlessly into any home or office decor. Their lightweight design facilitates easy mobility, enabling users to place them in various locations as needed.

Energy efficiency is another significant characteristic featured in these air purifiers. Many of the models are ENERGY STAR certified, which means they meet strict energy efficiency guidelines set by the U.S. Environmental Protection Agency. This not only helps reduce electricity costs but also makes these purifiers an environmentally friendly choice.

Noise levels are kept to a minimum with these units, ensuring they operate quietly without disrupting daily activities such as work, sleep, or family time. This is particularly important in shared living spaces, where background noise can be a concern.

Overall, Guardian Technologies presents an impressive lineup of air purifiers through models 004702-0, 004703-0, 004704-0, 004705-0, 004706-0, and 004707-0. Their combination of advanced filtration, smart technology, energy efficiency, and stylish design positions them as excellent options for anyone looking to improve their indoor air quality. Whether in a home or office, these models contribute significantly to a healthier living environment, making them a worthy investment for consumers seeking enhanced air purification solutions.
Top Page Image Contents