Guardian Technologies 5209 owner manual Emission Control System Warranty

Page 43

Section 10 – Warranty

Commercial-Industrial-Residential Portable Generator System

EMISSION CONTROL SYSTEM WARRANTY

Emission Control System Warranty (ECS warranty) for 2001 and later model year LSI engines:

(a)Applicability: This warranty shall apply to 1995 and later model year engines. The ECS Warranty period shall begin on the date the new engine or equipment is purchased by/delivered to its original, end-use purchaser/owner and shall continue for 24 consecutive months thereafter.

(b)General Emissions Warranty Coverage: Generac warrants to the original, end-use purchaser/owner of the new engine or equipment and to each subsequent purchaser/owner that each of its engines is...

(1)Designed, built and equipped so as to conform with all applicable regulations adopted by the CARB pursuant to its authority, and

(2)Free from defects in materials and workmanship which, at any time during the ECS Warranty Period, may cause a warranted emissions-related part to fail to be identical in all material respects to the part as described in the engine manufacturer's application for certification.

The ECS Warranty pertains only to emissions-related parts on your engine, as follows:

(1)Any warranted, emissions-related parts that are not scheduled for replacement as required maintenance in the Owner's Manual shall be warranted for the ECS Warranty Period. If any such part fails during the ECS Warranty Period, it shall be repaired or replaced by Generac according to Subsection

(4) below. Any such part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period.

(2)Any warranted, emissions-related part that is scheduled only for regular inspection as specified in the Owner's Manual shall be warranted for the ECS Warranty Period. A statement in such written instructions to the effect of "repair or replace as necessary" shall not reduce the ECS Warranty Period. Any such part repaired or replaced under the ECS Warranty shall be warranted for the remainder of the ECS Warranty Period.

(3)Any warranted, emissions-related part that is scheduled for replacement as required maintenance in the Owner's Manual shall be warranted for the period of time prior to first scheduled replacement point for that part. If the part fails prior to the first scheduled replacement, the part shall be repaired or replaced by Generac according to Subsection (4) below. Any such emissions-related part repaired or replaced under the ECS warranty shall be warranted for the remainder of the ECS Warranty Period prior to the first scheduled replacement point for such emissions-related part.

(4)Repair or replacement of any warranted, emissions-related part under this ECS Warranty shall be performed at no charge to the owner at a Generac Authorized Warranty Service Facility.

(5)When the engine is inspected by a Generac Authorized Warranty Service Facility, the purchaser/owner shall not be held responsible for diagnostic costs if the repair is deemed warrantable.

(6)Generac shall be liable for damages to other original engine components or approved modifications caused by a failure under warranty of any emission-related part covered by the ECS Warranty.

(7)Throughout the ECS Warranty Period, Generac shall maintain a supply of warranted emission-related parts sufficient to meet the expected demand for such emission-related parts.

(8)Any Generac authorized and approved emission-related replacement part may be used in the performance of any ECS warranty maintenance or repairs and will be provided without charge to the purchaser/owner. Such use shall not reduce Generac RCS Warranty obligations.

(9)Unapproved, add-on, modified, counterfeit and/or "grey market" parts nay not be used to modify or repair a Generac engine. Such use voids this ECS Warranty and shall be sufficient grounds for disallowing an ECS Warranty claim. Generac shall not be held liable hereunder for failures of any warranted parts of a Generac engine caused by the use of such an unapproved, add-on, modified, counterfeit and/or "grey market" part.

EMISSION RELATED PARTS INCLUDE THE FOLLOWING:

1) Fuel Metering System:

1.2) LPG/Natural Gas carburetion assembly and its internal components.

a)Fuel controller (if so equipped)

b)Mixer and its gaskets (if so equipped)

c)Carburetor and its gaskets (if so equipped)

d)Primary gas regulator (if so equipped)

e)LP liquid vaporizer (if so equipped)

2)Air Induction System including: a) Intake pipe/manifold

b) Air cleaner

3)Ignition System including: a) Spark plug

b) Ignition module

4)Catalytic Muffler Assembly (if so equipped) including: a) Muffler gasket

b) Exhaust manifold

5)Crankcase Breather Assembly including:

a) Breather connection tube

*Generac engine types covered by this warranty statement include the following: 1) Prepackaged Standby Generator

2) Auxiliary Power Unit (APU) Generator

3)Standby Generator

Part 2

41

Image 43
Contents Owner’s Manual Installation Guide For Generator Ready Kit Introduction General Hazards Important Safety InstructionsExplosion Hazards Electrical HazardsFire Hazards Assembling the Wheel KIT AssemblyAccessory BOX UnpackingHandle Assembly Battery ConnectionKnow the Generator Operation1 AC, 20 AMP, Duplex Receptacle Cord Sets and Connection Plugs2 120V AC, 20 AMP, Gfci Receptacle Provided. This receptacle can not recharge 6 Volt batteries 5 12 Volt DC, 10 AMP ReceptacleGrounding the Generator HOW to USE the GeneratorConnecting Electrical Loads DON’T Overload the GeneratorBefore Starting the Generator Wattage Reference GuideAdding Engine OIL Adding Gasoline To Start the EngineLOW OIL Pressure Shutdown System Stopping the EngineAutomatic Idle Control Cold Weather OPERATION/ DE-ICERTo recharge 12 Volt batteries, proceed as follows Charging a BatteryEngine Specifications Maintenance ScheduleProduct Specifications Generator SpecificationsGeneral Recommendations Generator MaintenanceEngine Maintenance Checking OIL Level To Clean the GeneratorClean Spark Arrestor Screen Service AIR CleanerReplacing the Spark Plug To adjust valve clearance Adjusting Valve ClearanceFuel Tank GeneralLong Term Storage Other Storage TipsSymptom Cause Solution TroubleshootingGenerator Ready KIT Plan the Location of Your Generator Safety and to discourage tampering Your Guardian Generator Ready KIT Is NOW Installed Operation of Generator with Generator Ready KIT Transfer to Generator Power Source When Utility Power Fails Interconnection Drawing Residential Portable Generator System Wiring Diagram Drawing No E0228 Schematic Drawing No E0229-A Section Part NO. QTY Description Detail a QTY Description Part NO#.QTY Generator Drawing No D4488-D QTY. Description 47,48 Heatsink Part NO. QTY. DescriptionFrame, Handle & Wheel Kit Drawing No E0695-A Special L/WASH QTY DescriptionCalifornia Emission Control Warranty Statement Emission Control System Warranty This Warranty Shall not Apply to the Following Warranty Schedule