Echo CS-352 instruction manual Operation, Fuel Requirements, Handling Fuel

Page 18
OPERATION

OPERATION

CS-352

 

 

OPERATION

Fuel

Alternative fuels, such as E-15 (15% ethanol), E-85 (85% ethanol) or any fuels not meeting ECHO requirements are NOT approved for use in ECHO 2-stroke gasoline engines. Use of alternative fuels may cause performance problems, loss of power, overheating, fuel vapor lock, and unintended machine operation, including, but not limited to, improper clutch engagement. Alternative fuels may also cause premature deterioration of fuel lines, gaskets, carburetors and other engine components.

Fuel Requirements

Gasoline - Use 89 Octane [R+M/2] (mid grade or higher) gasoline known to be good quality. Gasoline may contain up to 10% Ethanol (grain alcohol) or 15% MTBE (methyl tertiary-butyl ether). Gasoline containing methanol (wood alcohol) is NOT approved. ECHO brand Power Fuelis 93 octane, ethanol-free fuel premixed with ECHO Red Armor® engine oil at 50:1 ratio. Use of ECHO Power Fuelis recommended to extend engine life in all air-cooled 2-stroke and 2/4-stroke hybrid engines.

Two Stroke Oil - A two-stroke engine oil meeting ISO-L-EGD (ISO/CD 13738) and J.A.S.O. FD Standards must be used. Echo brand premium Power Blend XUniversal 2-Stroke Oil meets these standards. Engine problems due to inadequate lubrication caused by failure to use an ISO-L-EGD (ISO/CD 13738) and J.A.S.O. FD certified oil, such as Echo premium Power Blend X, will void the two-stroke engine warranty.

Echo premium Power Blend XUniversal 2-Stroke Oil may be mixed at 50:1 ratio for application in all Echo engines sold in the past regardless of ratio specified in those manuals.

Handling Fuel

Fuel is VERY flammable. Use extreme care when mixing, storing or handling, or serious personal injury may result.

Use an approved fuel container.

DO NOT smoke near fuel.

DO NOT allow flames or sparks near fuel.

Fuel tanks/cans may be under pressure. Always loosen fuel caps slowly allowing pressure to equalize.

NEVER refuel a unit when the engine is HOT or RUNNING!

DO NOT fill fuel tanks indoors. ALWAYS fill fuel tanks outdoors over bare ground.

DO NOT overfill fuel tank. Wipe up spills immediately.

Securely tighten fuel tank cap and close fuel container after refueling.

Inspect for fuel leakage. If fuel leakage is found, do not start or operate unit until leakage is repaired.

Move at least 3m (10 ft.) from refueling location before starting the engine.

18

X7503272504

© 08/2013 ECHO Inc.

Image 18
Contents Burn Hazard CS-352 CHAIN SAWTABLE OF CONTENTS TABLE OF CONTENTSCS-352 PACKING LIST CS-352PACKING LIST SAFETY SAFETYRules For Safe Operation Correct Use Of Chain Brake SAFETYTesting The Brake Chain Brake OperationOther Safety Precautions Automatic Chain BrakeNever suspend the saw on a lanyard with the engine running Eye Protection Personal Condition and Safety EquipmentPhysical Condition Hand ProtectionVibration and Cold Repetitive Stress InjuriesAll over head electrical conductors and communications wires can have electricity flow with high voltages. This unit is not insulated against electrical current. Never touch wires directly or indirectly, otherwise serious injury or death may result Symbols and Signs Symbol form/shapeEMISSION CONTROL EXHAUST / EVAPORATIVE Manual Safety Symbols and Important InformationEMISSION CONTROL EXHAUST / EVAPORATIVE EPA 2010 and Later and/or C.A.R.B. TIERDESCRIPTION DESCRIPTIONDESCRIPTION CHAIN SAW TERMSGuide Bar and Saw Chain Installation/Removal Preparation For UseTip Guard to Bar Instructions Adjusting Chain Tension Note All chains require frequent adjustments 6. Assemble components in reverse order7. Keep chain properly tensioned at all times Fuel OPERATIONOPERATION Fuel RequirementsChain Lubricant After useMixing Instructions Winter Operation Starting Cold EngineFor more information scan this QR code Chain brake Do not start engine before chain brake is locked Starting Warm Engine RunningChain Lubrication Test StoppingChecking Chain Tension Cutting Instructions3 m 10 feet Felling The TreeKickback Direction of fallFirst cut LimbingDirection of fall Hinge 5 cm 2 in Notch Second cutBucking Saw Chain Chain And Guide Bar CombinationGuide Bar Low-kickbackMaintenance Intervals MAINTENANCEMAINTENANCE Skill LevelsCarburetor Adjustment Engine Break-InHigh Altitude Operation Check Fuel System Air FilterSpark Plug Fuel FilterOil Filter SprocketCarbon deposits in muffler will cause drop in engine output and Cooling System CleaningSpark Arrestor Muffler overheating. Spark arrestor screen must be checkedExhaust Port Cleaning LevelSetting The Saw Chain Setting Saw ChainTo sharpen other chains, follow chain manufacturer’s instructions One fifth of the file diameter remains above cutter edgeTROUBLESHOOTING TROUBLESHOOTINGSTORAGE STORAGEStorage After Use TECHNICAL DATA TECHNICAL DATAECHO LIMITED WARRANTY STATEMENT FOR WARRANTY STATEMENTSWARRANTY STATEMENTS PRODUCT WARRANTY PERIOD RESIDENTIAL APPLICATIONATTENTION TWO-STROKE ENGINE POWER PRODUCT OWNERS WARRANTY STATEMENTSPURCHASED REPAIR PARTS, SHORT BLOCKS AND ACCESSORIES THIS WARRANTY DOES NOT COVER DAMAGE CAUSED BYCS-352 08/2013 ECHO IncCS-352 Additional or Replacement Manuals ServiceWarranty Registration Replacement Operator, Safety Manuals, and Parts CatalogsECHO, INCORPORATED 400 Oakwood RoadLake Zurich, IL
Related manuals
Manual 36 pages 7.13 Kb