Echo CS-352 Stopping, Checking Chain Tension, Chain Lubrication Test, Cutting Instructions

CS-352 OPERATION

Stopping

1.Release throttle trigger and allow engine to idle.

2.Move ignition switch (A) down to “stop” position.

Note: If engine does not stop, pull choke control knob out fully to stop engine.

Return the unit to your authorized ECHO dealer to check and repair stop switch before starting the engine again.

Checking Chain Tension

Chain tension should be checked frequently during work and corrected as necessary.

Do not operate with a loose chain.

Chain Lubrication Test

Hold the chain just above a dry surface and open the throttle to half speed for 30 seconds.

A thin line of “thrown” oil should be seen on the dry surface.

Cutting Instructions

General

For more information on scan this QR code.

•This chain saw is designed for cutting wood or wood products. Do not cut solid metal, sheet metal, plastic or any non-wood materials.

•Read the ECHO “CHAIN SAW SAFETY MANUAL” included with your chain saw for additional cutting and safety instructions.

•Wear suitable hearing protection such as earmuffs or earplugs to protect against objectionable or uncomfortable loud noises.

X7503272504 23

© 08/2013 ECHO Inc.