Specifications

	SPECIFICATIONS
	Models ZTR 4423 & ZTR 4426
CHASSIS:	Twin 12 gauge side frames and 7 gauge transmission and engine base plate.
BODY:	All body parts are made of high density polyethylene. Dent and corrosion
	resistant. Front body contains access panel for battery service.
MOWER DECK:	13 GA stamped steel construction.
	(3) blades combine for a 42" cut width.
	Cut height approximately 1" to 4" via 7 position lift handle.
BLADE DRIVE:	Electric clutch.
TRANSMISSION:	Each rear wheel is independently driven by chain and sprockets through a
ENGINE:	mechanical friction drive.

Model 4423:	15HP Vanguard Briggs & Stratton, 4-Cycle, Single Cylinder, Overhead
	Valve, Air-Cooled, Gasoline, Vertical Shaft With Cast Iron Cylinder Sleeve,
	Pressure Lubricated with oil filter.
Model 4426:	16HP Kohler Command 16, 4-Cycle, Single Cylinder, Overhead Valve, Air-
	Cooled, Gasoline, Pressure Lubricated, With Oil Filter, Vertical Shaft,
	Aluminum Head and Block with Cast-Iron Cylinder Liner.
STARTING SYSTEM:	Electric by key switch operation with safety interlock blade drive.
TIRES:	Front	11 X 4.00 X 5 ribbed tread.
	Rear	18 X 9.50 X 8 Turf Trac RS
RECOMMENDED	Front	16-21 lbs.
TIRE PRESSURE:
	Rear	8-14 lbs.
CAPACITIES:	Fuel	2.7 gallons total.
	Engine	Briggs & Stratton - 1.50 quarts oil.
		Kohler - 2 quarts oil with filter.
DIMENSIONS:	Width	47" outside rear wheel measurement.
	Height	42" to top edge of seat.
	Length	72" hitch tab to front bumper.
	Weight	520 lbs.
NOTE:	Additional information provided in service instructions under the individual component.
	SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

Page 11

Models ZTR 4423 & ZTR 4426

BODY:

MOWER DECK:

CAPACITIES:

DIMENSIONS: