Dixon 8950-598, ZTR 4426 manual Deck Removal

Page 27

CARE AND MAINTENANCE

DECK REMOVAL:

1.Place cut height lever in lowest cut position.

2.Pull belt idler back to allow belt to be removed from idler pulley and electric clutch pulley.

3.Remove hair pin cotter and washer from one end of deck support cross shaft. Note location of remaining shim washers used between chassis and mower deck plates. Slide shaft from chassis and mower deck.

4. Remove hair pin cotter and washer from each deck L-rod. Remove L-rods from lift arms. At this point, deck will drop down.

5.Carefully raise and support front of chassis. Slide mower deck to either side for removal. (Reverse procedure to reinstall deck assembly).

NOTE: When deck is reinstalled on frame, check that belt is correctly routed in the groves of all pulleys and that belt idler is applying tension to the back side of the belt.

Page 27

Image 27

Contents Series Important Read Carefully Index Safety Safety Symbols General Operation SafetyDo not Slope OperationChildren Service Dixon Protection Plus TWO Year Limited Warranty Policy Specifications Seat Adjustment Instructions Controls Parking Brake To SET Parking BrakeTransmission Drive System Braking To GO ForwardTo GO Backward TurningBlade Drive Circuit BreakerMower Deck CUT Height Lift Lever Before Operating Mower Operation InstructionsEngine should not turn over or attempt to start Testing of Safety Interlock SystemsStarting Instructions Mowing with a Mulching Attachment Mowing with a Grass Catcher Attachment Grass Height Suggestions Side Discharge of the ClippingsCare and Maintenance Maintenance ScheduleOFF-SEASON Battery Storage Cutter Blade Maintenance Transaxle Drive Belt Engine to Mower Deck BeltMower Deck Serpentine Belt Mower Deck Leveling Procedure Deck Removal OIL Filters Changing the Engine OILLubrication OIL FillRear Chain Adjustment Drive System Adjustments14 lbs. PSI Briggs & Stratton Filter Part Numbers Standard Service Parts ListBlades BeltsTroubleshooting Mower CUT QualitySituation Causes Remedy Drive System Electrical System Page Page Date OIL Changed Date Engine Tuned Owner Information4000Series