Dixon ZTR 4426, 8950-598 manual Cutter Blade Maintenance

Page 24

CARE AND MAINTENANCE

CUTTER BLADE MAINTENANCE:

NOTE: Observe proper blade position prior to removal.

1.Safely raise front of mower.

2.Hold or block blade from turning.

3.Loosen blade nut and remove blade.

4.When replacing blade, tighten blade nut securely. Refer to diagram.

CAUTION	Wear heavy, thick gloves when holding onto cutter blade.
	Avoid touching the sharp edge of the blade.

NOTE: BE SURE BLADE IS CENTERED ON PILOT BEFORE TIGHTENING NUT TO 60 FT. LBS. TORQUE.

Threaded end of Blade Shaft

Trash Guard

Mower Blade

Nut

Page 24

Image 24

Contents Series Important Read Carefully Index Safety Safety Symbols Safety General OperationSlope Operation Do notChildren Service Dixon Protection Plus TWO Year Limited Warranty Policy Specifications Seat Adjustment Instructions Controls Parking Brake To SET Parking BrakeTransmission Drive System To GO Forward To GO BackwardTurning BrakingBlade Drive Circuit BreakerMower Deck CUT Height Lift Lever Operation Instructions Before Operating MowerTesting of Safety Interlock Systems Engine should not turn over or attempt to startStarting Instructions Mowing with a Mulching Attachment Mowing with a Grass Catcher Attachment Side Discharge of the Clippings Grass Height SuggestionsCare and Maintenance Maintenance ScheduleOFF-SEASON Battery Storage Cutter Blade Maintenance Transaxle Drive Belt Engine to Mower Deck BeltMower Deck Serpentine Belt Mower Deck Leveling Procedure Deck Removal Changing the Engine OIL OIL FiltersOIL Fill LubricationDrive System Adjustments Rear Chain Adjustment14 lbs. PSI Standard Service Parts List BladesBelts Briggs & Stratton Filter Part NumbersTroubleshooting Mower CUT QualitySituation Causes Remedy Drive System Electrical System Page Page Owner Information Date OIL Changed Date Engine Tuned4000Series