Dixon RAM XS6025BF / 968999726 manual Fuel Shut Off Valve, Cutting Height Adjuster

Page 23

CONTROLS

9. Fuel Shut Off Valve

The fuel shut off valve is located at the left rear of the seat. The valve is off when the handle tab is turned perpendicular to the fuel line.

8011-419

Fuel shut off valve in the CLOSED position

10. Cutting Height Adjuster

The deck cutting height is obtained by pressing the foot pedal forward to lift the deck. To lower the deck, apply pressure to the top side of the foot pedal and allow it to pivot while the lift arm rotates to the rear of the unit. To stop in the desired cutting position, rotate the foot pedal down into the notch in the height plate. The cutting height range is from 1½" (38mm) to 4½" (114mm) in ¼ (6mm) increments. The heights are measured from the ground up to the blade tip with the engine not running.

IMPORTANT INFORMATION

In order to obtain an even cutting height, it is important that the air pressure in the front tires is 15 psi and the rear tires is 10 psi.

IMPORTANT INFORMATION

Always use the high position to transport.

The mower deck’s lifting lever

8050-117

English-23

Image 23
Contents Operator’s Manual Page Contents English-4 Introduction Manufacturing Number Good ServiceImportant Information Symbols and DecalsMoving sharp blades under cover General Operation SafetyNever take passengers Slope Operation Personal Safety EquipmentChildren Safe Handling of Gasoline General Maintenance Risk of sparking Transport Roll over Protection system Rops Control Locations Motion control levers Fuses ControlsSteering Control Levers Throttle Control Blade SwitchParking Brake Fuses Ignition SwitchChoke Control Fuel Tank Fuel Shut Off Valve Cutting Height AdjusterHour Meter Seat Adjustment LeverSteering OperationTraining Starting the Engine Before StartingPlace controls in neutral position To remove cables, reverse order Starting the engine with a weak batteryRunning Ensure that no one is near mower when engaging blade switchOperating on hills Mowing Tips Stopping the Engine Pump release valves Moving by HandMaintenance Before After MaintenanceMaintenance Schedule Daily Weekly Maintenance interval Least Hours OnceLeast in hours Once Before After Each Year 100 300 MaintenanceDaily Weekly At Replacing battery BatteryTo clean battery and terminals Ignition System Safety SystemChoke Cable Engine Cooling Air IntakeThrottle Cable Servicing Paper Element Air Filter MaintenanceServicing Precleaner Replacing Air FilterFuel Pump Air Filter Replacing the Fuel FilterBelts Tire PressuresDeck belt removal Deck belt installationReplacing pump belt Belt installationPump Belt Cutting BladesBlade replacement Leveling deck Adjusting the Mower DeckAdjusting Cutting Height Anti-scalp rollers Hardware Cleaning and WashingRemoval and installation of caster wheel Caster WheelsChange transaxles transmission filters General LubricationDeck spindle Lubricating the CablesFront Wheel Mount Front Wheel BearingsEngine Oil Filter Engine OilDeck outer spindle Engine Oil Levels Changing the Engine OilFluid Change Purging ProceduresHydraulic Pump Problem Cause TroubleshootingEnglish-54 Winter Storage ServiceStorage StorageSchematics Ram Xs5025 Technical DataProductivity Ram Xs7227 Engine 7227 Torque Specifications AccessoriesCE requirements Conformity CertificatesConformity Certificates USA requirementsDelivery Service Service JournalAfter the First 5-8 Hours Hour Service English-66 English-67 English-68 At Least Once Each Year Page Page Part No 132401 IR 11/15/07