Dixon RAM XS6025BF / 968999726, RAM XS5025BF / 968999725 Starting the engine with a weak battery

Page 28

OPERATION

Starting the engine with a weak battery

WARNING!

Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

IMPORTANT INFORMATION

Your mower is equipped with a 12-volt negative grounded system. The other vehicle must also be a 12-volt negative grounded system. Do not use your mower to start other vehicles.

If your battery is too weak to start the engine, it should be recharged. (See “Battery” in the Maintenance Section.)

If “jumper cables” are used for emergency starting, follow this procedure:

8011-642

To attach jumper cables

Jumper cable connection

Connect each end of the RED cable to the POSITIVE (+) terminal on each battery, taking care not to short against chassis.

Connect one end of the BLACK cable to the NEGATIVE (-) terminal of the fully charged battery.

Connect the other end of the BLACK cable to a good CHASSIS GROUND on the mower with the discharged battery, away from the fuel tank and battery.

To remove cables, reverse order

Remove BLACK cable first from chassis and then from the fully charged battery.

Remove RED cable last from both batteries.

English-28

Image 28
Contents Operator’s Manual Page Contents English-4 Introduction Good Service Manufacturing NumberSymbols and Decals Important InformationMoving sharp blades under cover Safety General OperationNever take passengers Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline General Maintenance Risk of sparking Transport Roll over Protection system Rops Controls Control Locations Motion control levers FusesSteering Control Levers Parking Brake Blade SwitchThrottle Control Choke Control Ignition SwitchFuses Fuel Tank Cutting Height Adjuster Fuel Shut Off ValveSeat Adjustment Lever Hour MeterTraining OperationSteering Before Starting Starting the EnginePlace controls in neutral position Starting the engine with a weak battery To remove cables, reverse orderEnsure that no one is near mower when engaging blade switch RunningOperating on hills Mowing Tips Stopping the Engine Moving by Hand Pump release valvesMaintenance Maintenance ScheduleDaily Weekly Maintenance interval Least Hours Once Maintenance Before AfterDaily Weekly At MaintenanceLeast in hours Once Before After Each Year 100 300 To clean battery and terminals BatteryReplacing battery Safety System Ignition SystemThrottle Cable Engine Cooling Air IntakeChoke Cable Air Filter Maintenance Servicing PrecleanerReplacing Air Filter Servicing Paper ElementReplacing the Fuel Filter Fuel Pump Air FilterTire Pressures BeltsDeck belt installation Deck belt removalBelt installation Pump BeltCutting Blades Replacing pump beltBlade replacement Adjusting Cutting Height Adjusting the Mower DeckLeveling deck Anti-scalp rollers Cleaning and Washing Removal and installation of caster wheelCaster Wheels HardwareLubrication Change transaxles transmission filters GeneralLubricating the Cables Front Wheel MountFront Wheel Bearings Deck spindleDeck outer spindle Engine OilEngine Oil Filter Changing the Engine Oil Engine Oil LevelsHydraulic Pump Purging ProceduresFluid Change Troubleshooting Problem CauseEnglish-54 Service StorageStorage Winter StorageSchematics Technical Data Ram Xs5025Productivity Ram Xs7227 Engine 7227 Accessories Torque SpecificationsConformity Certificates Conformity CertificatesUSA requirements CE requirementsService Journal Delivery ServiceAfter the First 5-8 Hours Hour Service English-66 English-67 English-68 At Least Once Each Year Page Page Part No 132401 IR 11/15/07