Dixon 13636-0702, ZTR 7525 manual Specifications, Seat

Page 13

 

SPECIFICATIONS

 

7500 Series

CHASSIS:

Folded sheet metal and rectangular tube

BODY:

Folded sheet metal

SEAT:

Designed for operator comfort with padded back and arm rests.

 

Seat is adjustable fore and aft.

MOWER DECK: Deck is made of 10 GA fabricated welded construction with 7 GA

 

reinforcement plates. Three blades combine for a 60" cut width.

 

Cut height approximately 1.5" to 5" via 10 position lift handle.

BLADE DRIVE:

Electric clutch

DRIVE SYSTEM:

Each rear wheel is independently driven by a HydroGear BDP

 

10A pump and a HydroGear HGM-15E hydraulic motor.

ENGINE:

25HP Kohler Command, 4-Cycle, V-Configuration, Overhead

 

Valve, Air-Cooled, Gasoline, Vertical Shaft, Aluminum Head, and

 

Crankcase with Cast Iron Liners, Full Pressure Lubrication/Full

 

Flow Filter, Pulse-type Fuel Pump, Fixed Jet Carburetor w/

 

Smart-Choke, Electronic Ignition, In-Line Fuel Filter, Dual Element

 

Air Cleaner.

STARTING

Electric by key switch operation with safety interlocks on parking

SYSTEM:

brake and blade drive clutch.

TIRES:

Front 13-5.00x6

 

Rear 23-9.50x12

RECOMMENDED Front

12 lbs.

TIRE PRESSURE: Rear

12 lbs.

CAPACITIES:

Fuel - 11 gallons (approx)

 

Hydrostat oil system - 4 qt with in-line 40 micron filter

 

Hydrostat oil recommendation, refer to page 31

 

Engine - 2 qts. SAE 10W30 (with filter)

DIMENSIONS:

Width

69-1/2"

 

Height

43"

 

Length

81”

 

Weight

916 lbs.

Additional information provided in service instructions under the individual component.

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE

13

Image 13
Contents Series Important Read Carefully Index Blade Contact TIP Over RUN Over Back Over SafetySafety Alert Symbol General Operation General Operation Do not Slope OperationChildren Service Service Dixon Limited Warranty Policy Hydro Gear Models Seat SpecificationsModel Seat Adjustment InstructionsControls To GO Forward Control LeversThrottle Control Lever Choke Control LeverParking Brake HYDRO-GEAR Drive SystemMower Deck CUT Height Lift Lever Blade DriveBefore Operating Mower Operation InstructionsTesting of Safety Interlock Systems Blade Drive Switch Test Electric Clutch Starting Instructions cold engine Engine cannot be restarted when blades are engaged Maintain Sharp Blades Throughout The Cutting Season Grass Height and Cutting Suggestions Do not attempt to cut grass when it is wetTo Free Wheel Machine Unlock Transmission Maintenance Schedule Care and MaintenanceEngine BatteryTires Belts Mower BladesHydrostatic Transmissions LubricationHydrostat OIL Maintenance Procedure Procedure for Raising and Lowering the Deck for Servicing Leveling the Deck Positionoperation Inshown Mower Shown in Servicing Position Engine WON’T Turn Over TroubleshootingEngine Idles Poorly Engine Backfires Model ZTR Standard Service Parts ListOwner Information ZTRMowers