Dixon 965882301, 46, 965882101, 965981001, 965882201, 965882001, 965882401, 54 manual Manual Transport

operation

•Move the steering controls outward.

•Remove key. Always remove key when leaving the mower to prevent unauthorized use.

8061-020

Place controls in neutral position

Manual Transport

WARNING!

Make no adjustments without:

•the engine stopped

•the ignition key removed

•the parking brake activated

When pushing or pulling the mower, engage the EZT (Integrated Zeroturn Transaxle) bypass linkages. The EZT bypass linkages are located on the rear of the frame, below the rear engine guard.

1.Raise the deck into the highest cutting position.

2.Pull the EZT bypass linkages up and out of the keyhole slots. Release the levers with the head outside the frame and held in the bypass position.

3.To reengage the EZT’s to drive, reverse the above procedure.

Load the machine into truck or trailer by driving up ramps in low gear. DO NOT LIFT! The machine is not intended to be lifted by hand.

8058-032

Bypass linkage, EZT engaged

8058-032

Bypass linkage, EZT locked in the bypass position

DIXON-33