Laser Compliance Statement
This laser product complies with EN/IEC
Safety Notes This device was shipped in perfect condition. In order to maintain this condition and to ensure safe operation, follow the safety instructions and warning notes written in this manual. Every person involved with installation and maintenance of this device has to:
Be qualified.
Follow the instructions in this manual.
CAUTION! Be careful when operating. DO NOT touch the housing or wires when the product is on to avoid a dangerous electric shock!
Important! CHAUVET® will not accept liability for any resulting damage caused by the
This product is not intended for permanent installation.
DO NOT mount this product within 50 cm of surrounding walls or large obstacles to allow for ventilation.
Never let the
Make sure that the available voltage is not higher than stated on the rear panel.
Make sure that the
Make sure that the
Always disconnect from power before cleaning or changing the fuse.
Never disconnect from power by tugging on the power cord.
It is essential to connect the yellow/green conductor to a ground (earth).
DO NOT attempt any repairs. The electric connection, repairs, and servicing must be carried out by a certified technician.
Do not switch the fixture on and off in short intervals as this will reduce the laser diode life.
Use fuses of same type and rating only.
The ambient temperature must be between 10°C to 40°C. Do not operate at temperatures outside this range.
If the product has been exposed to drastic temperature fluctuations, do not switch it on immediately. The arising water condensation might damage the product. Leave the device switched off until it has reached the ambient temperature.
Do not shake the device. Avoid brute force when mounting or operating the product.
When choosing the mounting location, make sure the product is not exposed to extreme heat, moisture, or dust.
Keep cables clear of vehicles and people. Otherwise you endanger your own and the safety of others!
ALWAYS use a safety cable attached to the safety eye hook when mounting the product overhead.
Use the original packaging when transporting.
Unauthorized modifications are forbidden for safety reasons!
CAUTION! Operate the device only after having familiarized yourself with its functions. Do not permit operation by unqualified persons. Most damages are the result of unprofessional operation.
CAUTION! DO NOT operate this device in ways not specified in this User Manual. Failure to follow the guidance in this manual will void the warranty, may damage the product, and injure the user or the audience.
Rev. 8 ML | 8 | Eclipse™ RGB User Manual |