3.SETUP
AC Power
Mounting
Orientation
Rigging
Proper Use
This product has an
This product may be mounted in any safe position, provided there is adequate room for ventilation.
It is important never to obstruct the fan or vents pathway. Mount the product using, a suitable “C” or “O” type clamp. Adjust the angle of the product by loosening both knobs and tilting the product. After finding the desired position, retighten both knobs.
When selecting installation location, take into consideration access and routine maintenance.
Safety cables must always be used.
Never mount in places where the product will be exposed to rain, high humidity, extreme temperature changes or restricted ventilation.
This product is for overhead mounting only. For safety purposes, CHAUVET® recommends mounting your lighting effect products on steady elevated platforms or sturdy overhead supports using suitable hanging clamps. In all cases, you must use safety cables. You can obtain appropriate mounting hardware from your lighting vendor.
International laser safety regulations require that laser products must be operated in the fashion illustrated below, with a minimum of 3 meters (9.8 ft) of vertical separation between the floor and the lowest laser light vertically. Additionally, 3 meters of horizontal separation is required between laser light and audience or other public spaces.
CAUTION - USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE
Eclipse™ RGB User Manual | 11 | Rev. 8 ML |