®3
INSTALLING THE W-85 WALL CONTROL
NOTE:
The wall control installs in the same manner as an ordinary light switch, using an existing wall box and wiring. This controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this reason the following precautions must be observed:
1.Use only the Casablanca
2.Do not use any additional control with your
3 fan (for example, dimmer, or fan speed control).
3.Do not use more than one fan per wall control.
4.No other light fixtures or electrical appliances may be connected on the circuit controlled by the
SINGLE W-85 INSTALLATION
CAUTION!
Ensure power is turned OFF at the breaker or fuse panel before starting installation.
1. Remove the screws and switch plate from the existing switch
box.
2. Remove the screws holding the switch in the switch box.
3. Pull the existing switch from the switch box to expose the wire
connections. |
|
| |
| |||
4. Remove the two wires from the switch. |
| ||
|
| ||
5. Connect the BLACK wire from the POWER SOURCE that you |
|
| |
just removed from the switch to the BLACK/WHITE STRIP wire |
|
| |
on the |
|
| |
nut. |
|
| |
|
|
|
|
|
|
|
|
NOTE: The RED wire is not used in this |
|
| |
application, DO NOT remove the crimped cap |
|
| |
from the wire.. |
| 2 BLACK | |
|
|
| |
|
|
| WIRES |
|
| ||
6. Connect the second BLACK wire that you just removed from the switch to the second BLACK wire on the located on the back of the
7.Connect the green ground wire coming from the back of the
8.Check your work by using the wiring diagrams as
shown in Figures # 1 and #2.
9.Install the
10.Install the wall plate with the two
(FIGURE #2)
(FIGURE #1)
Wall Control
RED WIRE
NOT USED
BLACK AND WHITE
STRIPED WIRE
10