Bel Air® 
INSTALLING INSTRUCTIONS
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
IMPORTANT! To avoid possible damage to the Halogen bulb holder the fan must be placed on the styrofoam packaging from the box. After removing the top cover from the upper half of the styrofoam, take the packaging from the box and put it on the floor. Place the fan in the recessed circle that the top cover was in.
PERMA•LOCK HARDWARE
ALLEN SET SCREW
downrod & Ball
alleassembly
ALLEN WRENCH
FAN PREPARATION
important safety information! | motor |
before starting the installation of your ceiling fan, | |
install the threaded downrod into the | wires |
motor coupling and lock the assembly |
|
|
|
ground
Prepare for fan installation as follows:
Step A. Route the wires from the motor through the Perma•Lock™ downrod and ball assembly.
Tip: The downrod has a tapered thread that is designed to lock completely when correctly installed.
Step B. Using the provided allen wrench, loosen the set screw several turns to allow installation of the downrod. Thread the downrod into the motor coupling until it stops turning, this will take at least four and a half full turns.
Step C. Securely tighten the set screw with the provided allen wrench to ensure safe operation of your fan.
CAUTION: Failure to fully lock in the downrod before securely tightening the set screw may cause the fan to separate from the downrod during normal operation!
tapered thread
ALLEN
SET SCREW
wire
downrod
&Ball assembly
motor
coupling
CEILING HARDWARE
CROSSBAR | WIRE NUT (4) |
MOUNTING |
|
BRACKET |
|
additional hardware
21/4″ x
1″ x | FLAT |
head screw (2) | WASHER (2) |
GETTING STARTED
Installing a New Ceiling Fixture Outlet Box | Using Existing Ceiling Fixture Outlet Box |
If you do not have an existing fixture located where you wish | After turning the power OFF at its source (either circuit |
to place your Casablanca fan,an approved ceiling fixture outlet | breaker or fuse box), lower the old fixture and disconnect |
box must be installed and wired. | the wiring. Check the ceiling fixture outlet box to be sure |
Warning: To reduce the risk of fire, electrical shock, or | that it is marked ‘Approved for ceiling fan mounting’. If it is |
personal injury, mount to outlet box marked acceptable for | not, a new box must be installed. |
ceiling fan support using the mounting hardware provided |
|
with the outlet box. |
|
3