Figure #2 | Casablanca Fan Company 3811Z, 3873Z, 38546Z specs

®3

W-85 CONTROL INSTALLATION

WALL CONTROL AND HARDWARE (not to scale)

W-85	Switch Mounting	Switch Bezels			Wall Plate	(4) Wire Cap
			White Wall	Almond Wall	Screws
Wall Control		(1) White
	Screws (2)		Plate(1)	Plate(1)	(2) White
		(1) Almond
					(2) Almond

WARNING!

To avoid possible electrical shock, make cer- tain that electricity is turned off at the circuit breaker or fuse box before attempting any in- stallation or repair procedure

CAUTION! NOT turning the power OFF at the circuit breaker or fuse box may cause damage to the electronics within the wall control and or the PC board on the fan.

Before installing the W-85 wall control you will need to check and see if you will need to change the bezel on the front of the wall control from WHITE to ALMOND. If you are going to use white, skip these steps and go to wall control installation starting on page 1. The bezel can be changed at any time before or after installation. The wall control does not need to be uninstalled to replace the bezel.

W-85 Wall Control Bezel Replacement installation as follows

Figure #1

WHITE

BEZEL

TABS

Step 17a. Locate the four (4) tabs holding the bezel to the front of the switch, then press in on each tab one at a time, removing the bezel as shown in Figure #1.

LOCATING

PINS

HOLES(4)

Step 17b. Locate the rubber key pad attached to the four (4) locating pins as shown in Figure #2 and remove rubber key pad from the WHITE bezel, also as shown in Figure #2.

LOCATING

PINS (4)

RUBBER KEY

PAD