Casablanca Fan Company 3811Z, 3873Z, 38546Z warranty Dual W-85 Installation, DIP Switches

®3

DUAL W-85 INSTALLATION

To control the fan and lights from two locations (a three-way circuit), use two W-85 wall controls as shown in the wiring diagram in Figure #5. Before installing the two switches into the wall, place both switches side by side, then locate the 4 dip switches on the side of the two switches. Then make sure that the dip switches are set to the same address on both switches as shown in Figure #4. When setting these dip switches you are setting the channel number that is required to control both your fan and lights from both sides of the room. If you are installing other Inteli-Touch®3 fans within your home you may need to reset the dip switches on these other fans to a different channel before installing your W-85 wall control into the wall. Please review the section on channel changing on this instruction sheet.

CAUTION!

Ensure power is turned OFF at the breaker or fuse panel before starting

installation.

WHITE

DIP SWITCHES

(FIGURE #4)

GREEN BLACK

Tocontrolthefanandlightsfromtwolocations(athree-waycircuit),usetwo W-85 wall controls.

	BLACK WITH
	WHITE STRIPE
GREEN	GREEN
W-85	W-85
RED
BLACK WITH
WHITE STRIPE
BLACK	BLACK
RED	RED
BLACK	BLACK
	RED
120V AC	BLACK
BLACK

BLACK	1. Remove the screws and switch plate from the existing switch box and the
	screws holding the switch in the switch box.
	2. Pull the existing switch from the switch box to expose the wire connections.
	3. Determine which wire is connected to the common terminal from the power
	source (120V AC) of the three-way switch. (The terminal will be marked
	on switch).

4.Remove the wire from the common terminal of the three-way switch. Connect this wire to the remaining black/white striped wire on the W-85 control. Secure this splice with a wire nut.

5.Remove the two remaining wires from the three-way switch. Connect the black wire of these wires to a black wire on the W-85 control. Secure the splice with a wire nut. The remaining red wire is to be connected to the other red wire on the

W-85. Secure the splice with a wire nut.

6.Connect the green ground wire coming from the back of the W-85 control to the ground wire in the switch box. Secure the splice with a wire nut.

7.Check your work by using the wiring diagrams as shown in Figure #5 on this page.

8.Install the W-85 in the wall box with the two long screws provided.

9.Install the wall plate with the two short color-matched screws provided.

W-85

2 BLACK Wall Control

WIRES

2 RED WIRES

BLACK AND WHITE

10.Installation of the second W-85 control is identical. Repeat steps 1 through 9.

(FIGURE #5)

STRIPED WIRE

11