VERSA•TOUCH2® Control INSTALLATION
Versa•Touch2™ Hardware (not to scale)
|
| Drywall | Wood | Screw | Screw |
| 12v Battery | Screw | |||
| Anchor | 1" (2) | (2) | (2) | |
|
|
| |||
|
|
|
| ||
Control | Control Holder |
|
|
|
|
Control Bracket Installation
SAFETY FIRST: To reduce the risk of electrical shock, this fan must be installed with an isolating wall control/
switch. CAUTION! Do not use with wall dimmer.
WARNING: To reduce the risk of fire or electric shock, do not use this fan with any solid state speed control
device. Use only the control provided with this fan.
Step 17. Follow instructions for the type of transmitter control bracket you will be using.
Standard
Toggle
Switch
Inner
Mounting
holes
Switch
Cover
Plate
Control
Bracket
Standard Light Switch
Step A. Remove the two screws holding the switch cover plate. Do not remove the cover plate.
Step B. Orient the control bracket as shown and line up the two inner mounting holes with those on the switch.
Step C. Insert and tighten the screws using the provided screwdriver.
Wall Installation
Step A. Locate a 2x4 wall stud in a convenient location.
Step B. Orient the control bracket as shown over the 2x4 stud.
Step C. Insert the 1" wood screws in either the inner or outer mounting holes and tighten using the provided screwdriver.
Rocker
Light
Switch
Outer
Mounting
Holes
Switch
Cover
ControlPlate
Bracket
Rocker Light Switch
Step A. Break off the two tabs by pushing outward.
Step B. Remove the two screws holding the switch cover plate. Do not remove the cover plate.
Step C. Orient the control bracket as shown and line up the two inner mounting holes with those on the switch.
Step D. Insert and tighten the screws using the provided screwdriver.
NOTE: The wall anchors and
Anchor
Panhead
Screw | Drywall Anchor |
Wood | Decor Ovalhead Screw |
Screw 1" |
8