Bush Hog 300 manual PRE-OPERATION Inspection and Service, Tractor Pre-Operation Inspection/Service

Page 40
(SG-21)

OPERATION

OPERATION

7. PRE-OPERATION INSPECTION AND SERVICE

Before each use, a pre-operation inspection and service of the implement and tractor must be performed. This includes routine maintenance and scheduled lubrication, inspecting that all safety devices are equipped and functional, and performing needed repairs. DO NOT operate the unit if the pre-operation inspection reveals any condition affecting safe operation. Perform repairs and replacement of damaged and missing parts as soon as noticed. By performing a thorough pre-operation inspection and service, valuable down time and repair cost can be avoided. OPS-U-0029

Periodically inspect all moving parts for wear and replace when necessary with authorized service parts. Look for loose fasteners, worn or broken parts, and leaky or loose fittings. Make sure all pins have cotter pins and washers. Serious injury may occur from not maintaining this machine in good working order.

7.1 Tractor Pre-Operation Inspection/Service

Refer to the tractor operator’s manual to ensure a complete pre-operation inspection and scheduled service is performed according to the manufacturers recommendations. The following are some of the items that require daily service and inspection:

•Tire condition/air pressure

•Wheel lug bolts

•Steering linkage

•PTO shield

•SMV sign is clean and visible

•Tractor’s lights are clean and functional

•Tractor Seat belt is in good condition

•Tractor ROPS is in good condition

•ROPS is in the raised position

•No tractor oil leaks

•Radiator free of debris

•Engine oil level and condition

•Engine coolant level and condition

•Power brake fluid level

•Power steering fluid level

•Fuel condition and level

•Sufficient lubrication at all lube points

•Air filter condition OPS-U-0030

300 Series 09/10

Operation Section 4-10

© 2010 Alamo Group Inc.

Page 39 Page 41
Image 40
Page 39 Page 41
Contents Series Rear Mounted BladeTo the Owner/Operator/Dealer Table of Contents Page Safety Section Safety Safety MessagesSeries 09/10 Safety Section Safety Safety Safety S3PT-02 See Your Bush HOG Dealer Decal Location QTY Level Description Decal Description Safety Logo Product Name Safety Federal Laws and Regulations Page Introduction Section Introduction IntroductionIntroduction Before Operating this Machine Assembly Section Assembly Assembly of Moldboard to MainframeAssembly Gauge Wheel Extra Equipment Skid Shoes & Quick Tack End Plates Extra EquipmentHydraulic Control Valve Accessory Equipment Hydraulic SystemSelector Valve Accessory Equipment Operation Section Operation OperationStandard Equipment and Specifications Operator Requirements Personal Protective Equipment PPETractor Requirements Tractor HorsepowerRops and Seat Belt Getting on and OFF the Tractor Front End WeightTractor 3-Point Hitch Boarding the Tractor Dismounting the TractorStarting the Tractor Connecting the Rear Blade to the Tractor Connecting the Rear BladePRE-OPERATION Inspection and Service Tractor Pre-Operation Inspection/ServiceBlade Pre-Operation Inspection/Service Do not Operate an Unsafe Tractor or Implement Tractor PRE-OPERATION Inspection Driving the Tractor and Implement Brake and Differential Lock Setting Starting the TractorOperating the Tractor and Implement Driving the Tractor and BladeOperating the Blade Ditching V-Type DitchDisconnecting the Blade from the Tractor Shutting Down the ImplementBlade Storage Transporting the Tractor and ImplementTransporting on Public Roadways Operation Hauling the Tractor and Implement Operation Troubleshooting Guide Problem Possible Cause RemedyOperation Page Maintenance Section Maintenance LubricationProper Torque For Fasteners Limited Warranty To the OWNER/OPERATOR/DEALER Series Rear Mounted Blade
Top Page Image Contents