Bush Hog 300 manual Starting the Tractor, Brake and Differential Lock Setting

Page 45

OPERATION

8.1 Starting the Tractor

The procedure to start the tractor is model specific. Refer to the tractor operator’s manual for starting procedures for your particular tractor. Consult an authorized dealer if the starting procedure is unclear. Ensure the 3-point control lever is in the lowered position and the PTO is disengaged before starting the tractor. OPS-U-0033

8.2 Brake and Differential Lock Setting

Make sure the tractor brakes are in good operating condition. Tractor brakes can be set to operate independently allowing single rear wheel braking action or locked together to provide simultaneous rear wheel braking. FOR MOST DRIVING AND OPERATING CONDITIONS, THE BRAKE PEDALS SHOULD BE LOCKED TOGETHER TO PROVIDE THE MOST EFFECTIVE BRAKING ACTION.

Always disengage the tractor differential lock when turning. When engaged the differential lock will prevent or limit the tractor from turning. During normal cutting conditions, locking the differential provides no benefit and should not be used. OPS- U- 0013

Be aware of the operating conditions. Do not operate the Tractor with weak or faulty brakes. When operating down a hill or on wet or rain slick roads, the braking distance increases; use extreme care and reduce your speed in these conditions. When operating in traffic, always use the Tractor’s flashing warning lights and reduce your speed. Be aware of traffic around you and watch out for the other guy.

300 Series 09/10

Operation Section 4-15

© 2010 Alamo Group Inc.

OPERATION

Image 45
Contents Rear Mounted Blade SeriesTo the Owner/Operator/Dealer Table of Contents Page Safety Section Safety Messages SafetySeries 09/10 Safety Section Safety Safety Safety S3PT-02 See Your Bush HOG Dealer Decal Location QTY Level Description Decal Description Safety Logo Product Name Safety Federal Laws and Regulations Page Introduction Section Introduction IntroductionIntroduction Before Operating this Machine Assembly Section Assembly of Moldboard to Mainframe AssemblyAssembly Skid Shoes & Quick Tack End Plates Extra Equipment Gauge Wheel Extra EquipmentHydraulic System Hydraulic Control Valve Accessory EquipmentSelector Valve Accessory Equipment Operation Section Operation OperationStandard Equipment and Specifications Personal Protective Equipment PPE Operator RequirementsTractor Horsepower Tractor RequirementsRops and Seat Belt Front End Weight Getting on and OFF the TractorTractor 3-Point Hitch Dismounting the Tractor Boarding the TractorStarting the Tractor Connecting the Rear Blade Connecting the Rear Blade to the TractorTractor Pre-Operation Inspection/Service PRE-OPERATION Inspection and ServiceBlade Pre-Operation Inspection/Service Do not Operate an Unsafe Tractor or Implement Tractor PRE-OPERATION Inspection Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock SettingDriving the Tractor and Blade Operating the Tractor and ImplementDitching V-Type Ditch Operating the BladeShutting Down the Implement Disconnecting the Blade from the TractorTransporting the Tractor and Implement Blade StorageTransporting on Public Roadways Operation Hauling the Tractor and Implement Operation Problem Possible Cause Remedy Troubleshooting GuideOperation Page Maintenance Section Lubrication MaintenanceProper Torque For Fasteners  Limited WarrantyTo the OWNER/OPERATOR/DEALER Series Rear Mounted Blade