Black & Decker 598968-00 instruction manual Trouble Shooting Guide, Problem Solution

Page 10

TROUBLE SHOOTING GUIDE

 

PROBLEM

SOLUTION

1.

Mower doesn’t run when switch lever is activated.

A. Check to make sure safety key has been installed and is

 

 

fully seated.

 

 

B. Ensure bail handle and switch lever are in “off” position.

 

 

Remove safety key, turn mower over and check that blade

 

 

is free to turn.

 

 

C. Has battery been fully charged? Plug in charger and wait

 

 

for green light to come on.

 

 

 

2.

Motor stops while mowing.

A. Ensure bail handle and switch lever are in “off” position.

 

 

Remove Safety Key. Turn mower over and check that blade

 

 

is free to turn.

 

 

B. Raise cutting height of wheels to highest position and start

 

 

mower.

 

 

C. Has battery been fully charged? Plug in charger and wait

 

 

for green light to come on.

 

 

D. Circuit breaker may have tripped. It resets automatically.

 

 

Re-set time could be as long as 1 minute. Slow down or

 

 

raise cut height.

 

 

 

3.

Mower runs but cutting performance is unsatisfactory,

A. Has battery been fully charged? (See Problem 1, Solution

 

or does not cut your entire lawn.

“C”.)

 

 

B. Ensure bail handle and switch lever are in “off” position.

 

 

Remove Safety Key. Turn mower over and check:

 

 

*Blade for sharpness

 

 

*Deck and discharge chute for clogging.

 

 

C. Wheel height adjustment may be set too low for grass

 

 

condition. Raise cutting height.

 

 

 

4.

Mower is too hard to push.

A. Raise cutting height to reduce deck drag on grass. Check

 

 

each wheel for free rotation.

 

 

 

5.

Mower is abnormally noisy and vibrates.

A. Ensure bail handle and switch lever are in “off” position.

 

 

Remove Safety Key. Turn mower on side and check blade

 

 

to ensure it has not been bent or damaged. If blade is

 

 

damaged, replace with a Black & Decker replacement

 

 

blade. If the underside of the deck is damaged return

 

 

mower to a Black & Decker Authorized service depot.

 

 

B. If there is no visible damage to the blade and the mower

 

 

still vibrates, return the mower to an authorized Black &

 

 

Decker service depot.

 

 

 

NOTE

Should the red light remain on after charging the battery for 24 hours on initial charge, the mower can still be used. The battery may need to be “conditioned” requiring a few battery charge and discharge cycles before the green indicator light comes on.

THIS IS ONLY A GUIDE INTENDED TO ENABLE YOU TO PERFORM VISUAL CHECKS AND SIMPLE TESTS. SHOULD NONE OF THE SOLUTIONS PROVIDE SATISFACTION OR IMPROVE PERFORMANCE CALL 1-800-762-6672 TO SPEAK TO A CONSUMER SERVICE REPRESENTATIVE OR TAKE THIS MOWER TO THE CLOSEST AUTHORIZED BLACK & DECKER SERVICE CENTRE FOR SERVICING.

10

Image 10
Contents CMM1000 Never Allow Children to Operate a Power Mower Important Safety RulesUSE Identical Replacement Blades only MOW only in Daylight or in Good Artificial LightBattery Operation & Care Charger Safety RulesWheel Height Adjustment 1-3/4 to 3-1/2 Charging ProcedureHandle Adjustment UnpackingOperation Installing Mulch Insert Battery GaugeSafety Shield and Rear Door Installing Grass CatcherMowing Tips Mulching Mowing TipsBlade Balancing CleaningBlade Sharpening Removing and Attaching BladesPage Trouble Shooting Guide Problem SolutionSave These Instructions for Future USE Utiliser Seulement DES Lames DE Rechanges Identiques Importantes Mesures DE SécuritéConserver CES Mesures À Titre DE Référence NE Laisser Jamais UN Enfant Utiliser LA TondeuseMesures Relatives AU Chargeur Entretien ET InstallationUtilisation ET Entretien DES Piles Caractéristiques ParticulièresChargement DéballageAssemblage DU SAC À Herbe FIG. S1, S2, S3 ET S4 Réglage DU GuidonFonctionnement Indicateur DE L’ÉTAT DE LA Pile Installation DE LA Plaque DE DéchiquetageInstallation DU SAC À Herbe Écran Protecteur ET Porte ArrièreConseils Relatifs À LA Tonte Conseils Relatifs À LA Désintégration DES Brins D’HERBEÉquilibrage DE LA Lame Retrait ET Installation DE LA LameAffûtage DE LA Lame LubrificationPage Page Page S1S2 S3S4 Rangement Problème Solution Liste DE Vérification DES ProblèmesConserver CES Mesures À Titre DE Référence Reglas DE Seguridad Importantes Operacion Y Cuidados a LA Bateria Reglas DE Seguridad Para EL CargadorProcedimiento DE Carga DesempacadoEnsamblaje DE LA Bolsa Para Pasto Figuras S1, S2, S3, S4 Ajustes AL MangoOperacion Para Quitar EL Inserto DE Desbroce Medidor DE BateriaEscudo DE Seguridad Y Puerta Trasera Instalación DEL Inserto DE DesbroceRecomendaciones Para Podado Recomendaciones Para DesbrozarRemocion E Instalacion DE Cuchillas Afilado DE LA CuchillaBalanceo DE LA Cuchilla LubricacionPage Problema Solucion NotaConserve Estas Instrucciones Para Referencias Futuras Cat. No. CMM1000 Form No Copyright 2005 Black & Decker July Page Page Page Page Page Page Page Page Page Page Page Page