Black & Decker 598968-00 Unpacking, Assembling the Grassbag Figure S1, S2, S3, S4

Page 4

PLEASE REFER TO DIAGRAMS (A, B, C...) AND ITEM NUMBERS (1, 2, 3...) AS NOTED THROUGHOUT MANUAL.

UNPACKING

Your mower has been completely assembled at the factory except for the Grassbag.

To remove mower from carton

1.Remove the Grassbag frame and cardboard fillers.

2.Remove the mower from the carton and place all four wheels on the ground or floor.

3.Check the carton thoroughly and make sure there are no loose parts.

To Unfold Handle

Raise the handle section B-1 into place and secure by tightening the two lower knobs. B-2. Remove safety key from handle.

WARNING: Sharp moving blade. For your own safety DO NOT use this mower without either the Grasscatcher, Mulch Insert, or optional discharge chute in operating position serious injury could result.

ASSEMBLING THE GRASSBAG (FIGURE S1, S2, S3, S4)

1.Shut mower off, wait until blade stops and remove Safety Key A-7.

2.Before starting to assemble the grassbag to the frame, check that the grassbag and frame are similar to figure S1.

3.Slide the grassbag onto the frame as shown in figure S2.

4.Assemble the top clips to the frame as shown in figure S3, then assemble the two side clips and the bottom clip last.

5.Completely assembled grasscatcher see figure S4.

CHARGING PROCEDURE

The charger on your mower is a specially designed 2-step charger.

Step 1: The recharge cycle is indicated by the illuminated red light (A-1).

Step 2: The maintenance cycle is indicated by the illuminated green light (A-2).

This cycle will maintain your mower in a fully charged condition.

1.Remove safety key A-7.

2.Plug the charger connector A-3 into the receptacle A-9 on the mower.

3.Insert the 120 volt plug A-4 of the charger A-5 into the wall receptacle.

4.The red light on the mower should come on indicating you have power and the battery is being charged. The red light should extinguish and the green light will come on when charging is complete (takes approximately 24 hours to charge a fully discharged mower).

5.It is recommended to leave the mower on constant charge for optimum performance during the mowing season.

HANDLE ADJUSTMENT

Your mower has a variable height handle adjustment feature. To adjust the handle position to suit your height preference, use the following procedure:

1.Remove both knobs C-1 on the middle part of the handlebars and remove the bolts C-2.

2.Slide the upper handle into one of the 3 adjustment positions C-3, aligning the holes in the upper and lower handles.

3.Insert the saddle bolts and install the knobs, tightening securely. The knobs should always be on the outside of the handles to avoid interference with the rear door and grass bag.

WHEEL HEIGHT ADJUSTMENT (1-3/4” TO 3-1/2”)

1.Before making any adjustments, release bail handle to turn mower off, wait for blade to stop, and remove safety key.

2.Your mower features the Black & Decker one touch wheel height adjustment system. This system will adjust all four wheels at the same time.

3.To raise or lower the cutting height, place the palm of your hand on the palm rest D-1 and with your fingers, squeeze upward on the finger grip D-2 and hold.

4.While holding the finger grip up you can raise or lower the cutting height. The mower has seven blade height adjustment positions. Refer to the scale E-1 and pointer E-2 at the front of the mower. The pointer will indicate the height setting for cutting your lawn. This setting can be a reference for the next time you want to cut your lawn at the same height.

When you have the mower at the height you would like, hold it in place with your left hand on the lower right handle bar and release the finger grip with your right hand to lock the height adjust.

Note: To ensure that the deck is securely locked in one of the seven positions, press down on the palm rest after releasing the finger grip.

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents CMM1000 Important Safety Rules USE Identical Replacement Blades onlyNever Allow Children to Operate a Power Mower MOW only in Daylight or in Good Artificial LightBattery Operation & Care Charger Safety RulesCharging Procedure Handle AdjustmentWheel Height Adjustment 1-3/4 to 3-1/2 UnpackingOperation Battery Gauge Safety Shield and Rear DoorInstalling Mulch Insert Installing Grass CatcherMowing Tips Mulching Mowing TipsCleaning Blade SharpeningBlade Balancing Removing and Attaching BladesPage Trouble Shooting Guide Problem SolutionSave These Instructions for Future USE Importantes Mesures DE Sécurité Conserver CES Mesures À Titre DE RéférenceUtiliser Seulement DES Lames DE Rechanges Identiques NE Laisser Jamais UN Enfant Utiliser LA TondeuseEntretien ET Installation Utilisation ET Entretien DES PilesMesures Relatives AU Chargeur Caractéristiques ParticulièresDéballage Assemblage DU SAC À Herbe FIG. S1, S2, S3 ET S4Chargement Réglage DU GuidonFonctionnement Installation DE LA Plaque DE Déchiquetage Installation DU SAC À HerbeIndicateur DE L’ÉTAT DE LA Pile Écran Protecteur ET Porte ArrièreConseils Relatifs À LA Tonte Conseils Relatifs À LA Désintégration DES Brins D’HERBERetrait ET Installation DE LA Lame Affûtage DE LA LameÉquilibrage DE LA Lame LubrificationPage Page Page S1S2 S3S4 Rangement Problème Solution Liste DE Vérification DES ProblèmesConserver CES Mesures À Titre DE Référence Reglas DE Seguridad Importantes Operacion Y Cuidados a LA Bateria Reglas DE Seguridad Para EL CargadorDesempacado Ensamblaje DE LA Bolsa Para Pasto Figuras S1, S2, S3, S4Procedimiento DE Carga Ajustes AL MangoOperacion Medidor DE Bateria Escudo DE Seguridad Y Puerta TraseraPara Quitar EL Inserto DE Desbroce Instalación DEL Inserto DE DesbroceRecomendaciones Para Podado Recomendaciones Para DesbrozarAfilado DE LA Cuchilla Balanceo DE LA CuchillaRemocion E Instalacion DE Cuchillas LubricacionPage Problema Solucion NotaConserve Estas Instrucciones Para Referencias Futuras Cat. No. CMM1000 Form No Copyright 2005 Black & Decker July Page Page Page Page Page Page Page Page Page Page Page Page
Top Page Image Contents