Electric Start (120V or 240V)
(932035, 101, optional on 309, 503)
1.Connect extension cord to prongs on starter.
IMPORTANT: Prevent damage to unit. Know voltage of your starter and only use matching outlets.
2.Plug extension into:
240V
120V
3.Turn discharge chute straight ahead.
4.Make sure that the traction clutch and attachment drive clutch levers are fully disengaged.
5.Push Primer Bulb 2 or 3 times for cold engine.
NOTE: When temperature is below
6.Insert key into ignition switch on engine and push into "Run" position. DO NOT twist key after it is inserted.
7.If engine is cold, apply choke. A warm engine requires less choking than a cold engine. See Engine Manual for detailed instructions.
8.Set throttle to proper starting position.
9.Press starter button on engine until engine starts.
IMPORTANT: DO NOT operate starter more than 15 seconds per minute, as overheating and damage can occur. (If engine does not start, refer to Troubleshooting.)
10.Adjust choke as needed.
11.Disconnect power cord from outlet, then starter.
12.Set throttle to Part Throttle or Slow position for travel or adaptation to outside temperature. Once achieved, set throttle to Fast position for normal operation.
Shut Off
1.Release Traction Drive Clutch Lever and allow unit to come to a complete stop.
2.Run Impeller a few minutes after use to prevent
3.Release Attachment Clutch Lever and wait for all moving parts to come to a complete stop.
4.Move Throttle to the “Stop” position.
5.Remove key.
SNOW REMOVAL
IMPORTANT: Allow unit and engine to adjust to the outdoor temperatures before clearing snow.
NOTE: Attachment clutch should be engaged before wheel drive clutch when throwing snow.
1.Select Speed Control position and direction.
2.Engage Attachment Clutch - Right Hand Lever.
3.Engage Traction Drive Clutch - Left Hand Lever.
IMPORTANT: DO NOT overload unit capacity by attempting to clear snow at too fast a rate. Use slow speed to clear deep or hard packed snow.
Tips for Operation
Snow is best removed as soon as possible after snow fall.
To clear an area, run unit in an overlapping series of paths. For large areas; start in the middle and throw snow to each side, so snow is not cleared more than once.
ALWAYS direct snow away from area to be cleared and with direction of the wind.
TRAVELING
To travel from one work area to another:
1.Set Throttle to Slow or
2.Press down on handlebars enough to raise front of unit slightly off surface.
3.Engage wheel drive clutch without engaging attachment drive clutch.
TRANSPORT
ALWAYS shut off engine, remove key and drain fuel when transporting unit on a truck or trailer.
Use extra care when loading or unloading unit onto trailer or truck.
Secure unit chassis to transport vehicle. NEVER secure from rods or linkages that could be damaged.
DO NOT transport machine while engine is running.
GB - 17