Alamo 1595 manual Storage and Parking Safety Instructions and Practices

Page 20
(SG-18)
(SL-27)
(SL-26)
(SG-38)

SAFETY

SAFETY

Avoid contact with hot surfaces of the engine or muffler. Use gloves and eye protection when servicing hot components. Contact with a hot surface or fluid can cause serious injury from burns or scalding.

Never allow anyone to get under the loader or attachment or to reach through the loader lift arms when raised. Serious injury could result from crushing or pinching by the loader or attachment. (SL-06)

PARTS INFORMATION

Rhino products are designed utilizing specifically matched system components to ensure optimum equipment performance. These parts are made and tested to Rhino specifications. Non-genuine "will fit" parts do not consistently meet these specifications. The use of “will fit” parts may reduce equipment performance, void warranties, and present a safety hazard. Use genuine Rhino parts for economy and safety. (SPRM-2)

SEE YOUR RHINO DEALER

Storage and Parking Safety Instructions and Practices

Never crawl under or allow children to play around or on a loader that is disconnected from the tractor. The loader could fall crushing a person resulting in serious injury or death. (SL-13)

Do not remove the attachment from the loader when the loader is disconnected from the tractor. The attachment stabilizes the loader. If the attachment is removed, the loader will fall and could result in serious injury.

Only disconnect and store the loader on firm flat ground. Make sure the loader stands are properly installed and rest on firm ground or support blocks. If the stands sink or fail, the loader could fall causing serious injury.

Concluding Safety Instructions and Practices

In addition to the design and configuration of this Implement, including Safety Signs and Safety Equipment, hazard control and accident prevention are dependent upon the awareness, concern, prudence, and proper training of personnel involved in the operation, transport, maintenance, and storage of the machine. Refer also to Safety Messages and operation instruction in each of the appropriate sections of the Tractor and Equipment Manuals. Pay close attention to the Safety Signs affixed to the Tractor and Equipment.

1595 01/11

Safety Section 1-16

© 2011 Alamo Group Inc.

Image 20
Contents 1595 To the Owner/Operator/Dealer Table of Contents Maintenance Section Safety Section Safety General Safety Instructions and Practices1595 01/11 Safety Section Operator Safety Instructions and Practices Safety Equipment Operation Safety Instructions and Practices SG-36 Safety Safety SL-33 Safety Safety Transporting Safety Instructions and Practices Maintenance and Service Safety Instructions and Practices Safety Storage and Parking Safety Instructions and Practices Concluding Safety Instructions and PracticesDecal Location QTY Level Description Decal Description Loader Positions 1595 01/11 Safety Section Loader Safety Safety Safety Federal Laws and Regulations Introduction Section Introduction Introduction Introduction Assembly and Connecting the Loader Section Assembly Dismounting and Mounting Mid-Mount Loader1595 01/11 Assembly Section Proper Rear Ballasting and Wheel Spacing Dismounting the Loader Mounting Loader Installing Quick Attach Device Assembling Quick Attach DeviceConnecting the Attachment When Connecting an Attachment to the Loader Quick HitchPlumbing Hydraulic Valve Hose Plumbing Attaching Valve Mounting & ValveAttaching Tractor Hydraulic Block Plumbing Loader to Control Valve Page Operation Section Operation Standard Equipment and Specifications Operator Requirements Operation Tractor Requirements Personal Protective Equipment PPETractor Requirements and Capabilities Rops and Seat BeltTractor Lighting and SMV Emblem Tractor BallastGetting On and Off the Tractor Boarding the TractorDismounting the Tractor Starting the Tractor Pre-Operation Inspection and Service Tractor Pre-Operation Inspection/ServiceLoader Pre-Operation Inspection/Service Mount Assembly OPS-L-0018A Do not Operate an Unsafe Tractor or Front END Loader Front END Loader PRE-OPERATION Inspection Driving the Tractor and Loader Brake and Differential Lock Setting Starting the TractorDriving the Tractor and Loader Operating the Tractor and LoaderSG-36 Operation 1595 01/11 Operation Section Operation Operating the Loader Filling the BucketOperation Lifting the Load Carrying the Load Dumping the Bucket Operating with Float Control Operation Peeling and Scraping Loading LOW Trucks or Spreaders from a Pile Backfilling Operation Handling Large Heavy Objects Operating Bale Spear Optional Attachment Loader Storage Shutting Down the ImplementTransporting the Tractor and Implement Operation Transporting on Public Roadways Hauling the Tractor and Implement Troubleshooting Guide Trouble Possible Cause Possible RemedyOperation Page Maintenance Section Maintenance 1595 01/11 Maintenance Section Lubrication Information Daily Checks Hydraulic CylinderLift and Bucket Cylinder Disassembly Lift and Bucket Cylinder ReassemblyStorage Maintenance Proper Torque for Fasteners Maintenance Maintenance Rhino To the OWNER/OPERATOR/DEALER SOM-01/11 F-4124C Printed U.S.A