Alamo 1595 Attaching Valve Mounting & Valve, Attaching Tractor Hydraulic Block, Hose Plumbing

ASSEMBLY

ASSEMBLY

Attaching Valve Mounting & Valve

1.Attach valve mounting stand on inside of right mid mount using M10 x 45 mm bolts, lockwashers, and hex nuts.

2.Attach valve to valve mounting stand with M8 x 50 mm bolts, lockwashers, and hex nuts. AsmP-L-0001

Attaching Tractor Hydraulic Block

1.Remove cover from tractor hydraulic area located under foot rest on right side of tractor. Align attaching holes in tractor with holes in hydraulic block. Install hydraulic block with O- rings in place using (4) bolts, lockwashers, and O-rings. (2 ports are on top & one port to lower front of tractor).

2.Install 90º pipe hydraulic elbow fitting in top front pressure port and point toward front of tractor.

3.Install straight pipe adapters into other two ports. (Figure Asmp-L-0002).

Hose Plumbing

1.Connect pressure hose from top front 90º elbow fitting on tractor hydraulic block to valve 90º elbow fitting left inlet on valve. (P Port).

2.Connect tank hose with tube 90º bend from hydraulic block lower front port (tank port) to 90º elbow fitting on front of valve. (T Port).

3.Connect power beyond hose with tube 90º bend from hydraulic block rear upper port (power beyond) to 90º elbow fitting on valve (on right side of valve). (See Figure AsmP-L-0002).

1595 01/11 Assembly Section 3-10

© 2011 Alamo Group Inc.