Alamo 1595 manual Driving the Tractor and Loader, Operating the Tractor and Loader

Page 63
(SL-21)
(SL-17)

OPERATION

6.3 Driving the Tractor and Loader

Start off driving at a slow speed and gradually increase your speed while maintaining complete control of the tractor and loader. Moving slowly at first will also prevent the tractor from rearing up and loss of steering control. The tractor should never be operated at speeds that cannot be safely handled or which will prevent the operator from stopping quickly during an emergency. If the power steering or engine ceases operating, stop the tractor immediately as the tractor will be difficult to control.

Perform turns with the tractor and loader at slow speeds to determine how the tractor with an attached implements handles a turn. Determine the safe speed to maintain proper control of the tractor when making turns. When turning with an implement, the overall working length of the unit is increased. Allow additional clearance for the loader when turning.

To avoid overturns, drive the tractor with care and at safe speeds, especially when operating over rough ground, crossing ditches or slopes, and turning corners. Tractor rear wheel spacing should be increased when operating on inclines or rough ground to reduce the possibility of tipping.

Use extreme caution when operating on steep slopes. Keep the tractor in a low gear when going downhill. DO NOT coast or free-wheel downhill. OPS-L-0030

6.4 Operating the Tractor and Loader

Do not attempt to lift loads in excess of loader capacity.

Operating loader on a hillside is dangerous. Extreme care is recommended. Keep bucket as low as possible.

Use extreme care when piling material above 6 feet high. Material could shift and fall onto the operator or bystanders. The material could crush or suffocate the operator or bystander resulting in serious injury or death.

Do not raise the loader on a hillside. Do not transport across a slope with a raised loader. When the loader is raised, the center of gravity of the tractor and loader is raised increasing the potential for the tractor to tip over. Tractor wheel contact with any wash out, drop off or the ground obstruction with a raised loader could result in the tractor tipping over and causing serious bodily injury.

Do not operate or raise the loader near the edge of a ditch or where loose soil can give way and allow the tractor to tip over. Keep the tractor tires away from loose soil or the edge of a drop off. Always wear your seatbelt when operating the loader to reduce the possibility of serious injury from a tractor tip over or roll over. (SL-24)

1595 01/11

Operation Section 4-19

© 2011 Alamo Group Inc.

OPERATION

Image 63
Contents 1595 To the Owner/Operator/Dealer Table of Contents Maintenance Section Safety Section General Safety Instructions and Practices Safety1595 01/11 Safety Section Operator Safety Instructions and Practices Safety Equipment Operation Safety Instructions and Practices SG-36 Safety Safety SL-33 Safety Safety Transporting Safety Instructions and Practices Maintenance and Service Safety Instructions and Practices Safety Concluding Safety Instructions and Practices Storage and Parking Safety Instructions and PracticesDecal Location QTY Level Description Decal Description Loader Positions 1595 01/11 Safety Section Loader Safety Safety Safety Federal Laws and Regulations Introduction Section Introduction Introduction Introduction Assembly and Connecting the Loader Section Dismounting and Mounting Mid-Mount Loader Assembly1595 01/11 Assembly Section Proper Rear Ballasting and Wheel Spacing Dismounting the Loader Mounting Loader Assembling Quick Attach Device Installing Quick Attach DeviceWhen Connecting an Attachment to the Loader Quick Hitch Connecting the AttachmentPlumbing Hydraulic Valve Attaching Valve Mounting & Valve Attaching Tractor Hydraulic BlockHose Plumbing Plumbing Loader to Control Valve Page Operation Section Operation Standard Equipment and Specifications Operator Requirements Operation Personal Protective Equipment PPE Tractor RequirementsTractor Ballast Tractor Requirements and CapabilitiesRops and Seat Belt Tractor Lighting and SMV EmblemBoarding the Tractor Getting On and Off the TractorDismounting the Tractor Starting the Tractor Tractor Pre-Operation Inspection/Service Pre-Operation Inspection and ServiceLoader Pre-Operation Inspection/Service Mount Assembly OPS-L-0018A Do not Operate an Unsafe Tractor or Front END Loader Front END Loader PRE-OPERATION Inspection Driving the Tractor and Loader Starting the Tractor Brake and Differential Lock SettingOperating the Tractor and Loader Driving the Tractor and LoaderSG-36 Operation 1595 01/11 Operation Section Operation Filling the Bucket Operating the LoaderOperation Lifting the Load Carrying the Load Dumping the Bucket Operating with Float Control Operation Peeling and Scraping Loading LOW Trucks or Spreaders from a Pile Backfilling Operation Handling Large Heavy Objects Operating Bale Spear Optional Attachment Shutting Down the Implement Loader StorageTransporting the Tractor and Implement Operation Transporting on Public Roadways Hauling the Tractor and Implement Trouble Possible Cause Possible Remedy Troubleshooting GuideOperation Page Maintenance Section Maintenance 1595 01/11 Maintenance Section Lubrication Information Hydraulic Cylinder Daily ChecksLift and Bucket Cylinder Reassembly Lift and Bucket Cylinder DisassemblyStorage Maintenance Proper Torque for Fasteners Maintenance Maintenance Rhino To the OWNER/OPERATOR/DEALER SOM-01/11 F-4124C Printed U.S.A