Alamo 1595 manual Operation

Page 67
(SL-21)
(SL-32)
(SL-31)
(SL-22)
(SPU-3)
(SL-35)

OPERATION

Operate the tractor and loader only in conditions where you have clear visibility in daylight or with adequate artificial lighting. Never operate in darkness or foggy conditions where you cannot clearly see at least 100 feet in front and to the sides of the tractor. Make sure you can clearly see bystanders, ditches, steep slopes, drop-offs, overhead obstructions, power lines, and debris or obstruction in the travel path. If you are unable to clearly see these types of items discontinue operating. Contact with unseen vehicles, bystanders, obstructions, or drop-offs can cause serious injury.

Never leave the Implement and Power Unit unattended while the Implement is in the raised position. Accidental operation of a lifting lever or a hydraulic failure may cause the implement to suddenly fall causing serious injury or possible death to anyone who might inadvertently be under the Implement. Lower the implement carefully to the ground. Do not put hands or feet under lifted components.

Make sure the hydraulic quick disconnects are fully seated into the connections. Do not use the loader if the hydraulic connection is leaking. Leaking oil could allow the loader to fall resulting in a serious crushing injury.

If the loader valve controls fail to functions properly discontinue use of the tractor and loader until the controls are properly repaired. Sudden or unexpected movement or dropping of the loader and attachment could result in serious injury.

Make sure all air is purged from the hydraulic system before using the loader. Air in the system can cause the loader to respond sluggishly or with unexpected movement. The air can be purged from the cylinder lines by fully cycling the cylinders several times from the fully closed to fully open position. Sudden or unexpected movement or dropping of the loader and attachment could result in serious injury.

Do not raise the loader on a hillside. Do not transport across a slope with a raised loader. When the loader is raised, the center of gravity of the tractor and loader is raised increasing the potential for the tractor to tip over. Tractor wheel contact with any wash out, drop off or the ground obstruction with a raised loader could result in the tractor tipping over and causing serious bodily injury.

Always have a heavy attachment, such as a bucket mounted on loader when it is removed from tractor.

It is important not to put excessive weight on parking stands with lift cylinder retraction. Damage may result.

1595 01/11

Operation Section 4-23

© 2011 Alamo Group Inc.

OPERATION

Image 67
Contents 1595 To the Owner/Operator/Dealer Table of Contents Maintenance Section Safety Section General Safety Instructions and Practices Safety1595 01/11 Safety Section Operator Safety Instructions and Practices Safety Equipment Operation Safety Instructions and Practices SG-36 Safety Safety SL-33 Safety Safety Transporting Safety Instructions and Practices Maintenance and Service Safety Instructions and Practices Safety Concluding Safety Instructions and Practices Storage and Parking Safety Instructions and PracticesDecal Location QTY Level Description Decal Description Loader Positions 1595 01/11 Safety Section Loader Safety Safety Safety Federal Laws and Regulations Introduction Section Introduction Introduction Introduction Assembly and Connecting the Loader Section Dismounting and Mounting Mid-Mount Loader Assembly1595 01/11 Assembly Section Proper Rear Ballasting and Wheel Spacing Dismounting the Loader Mounting Loader Assembling Quick Attach Device Installing Quick Attach DeviceWhen Connecting an Attachment to the Loader Quick Hitch Connecting the AttachmentPlumbing Hydraulic Valve Attaching Tractor Hydraulic Block Attaching Valve Mounting & ValveHose Plumbing Plumbing Loader to Control Valve Page Operation Section Operation Standard Equipment and Specifications Operator Requirements Operation Personal Protective Equipment PPE Tractor RequirementsTractor Ballast Tractor Requirements and CapabilitiesRops and Seat Belt Tractor Lighting and SMV EmblemBoarding the Tractor Getting On and Off the TractorDismounting the Tractor Starting the Tractor Tractor Pre-Operation Inspection/Service Pre-Operation Inspection and ServiceLoader Pre-Operation Inspection/Service Mount Assembly OPS-L-0018A Do not Operate an Unsafe Tractor or Front END Loader Front END Loader PRE-OPERATION Inspection Driving the Tractor and Loader Starting the Tractor Brake and Differential Lock SettingOperating the Tractor and Loader Driving the Tractor and LoaderSG-36 Operation 1595 01/11 Operation Section Operation Filling the Bucket Operating the LoaderOperation Lifting the Load Carrying the Load Dumping the Bucket Operating with Float Control Operation Peeling and Scraping Loading LOW Trucks or Spreaders from a Pile Backfilling Operation Handling Large Heavy Objects Operating Bale Spear Optional Attachment Shutting Down the Implement Loader StorageTransporting the Tractor and Implement Operation Transporting on Public Roadways Hauling the Tractor and Implement Trouble Possible Cause Possible Remedy Troubleshooting GuideOperation Page Maintenance Section Maintenance 1595 01/11 Maintenance Section Lubrication Information Hydraulic Cylinder Daily ChecksLift and Bucket Cylinder Reassembly Lift and Bucket Cylinder DisassemblyStorage Maintenance Proper Torque for Fasteners Maintenance Maintenance Rhino To the OWNER/OPERATOR/DEALER SOM-01/11 F-4124C Printed U.S.A