Alamo 2500 manual Hydraulic Control Valve Extra Equipment, Selector Valve Accessory Equipment

Page 29

ASSEMBLY

Hydraulic Control Valve (Extra Equipment)

A three-spool, four way Hydraulic Control Valve, open center or closed center, is available as Accessory Equipment. This allows you to operate four Hydraulic Cylinders from two remote outlets. Connect the 3-spool Valve to one outlet to operate three Cylinders. Use the other remote outlet to operate the fourth Cylinder.

If Closed Center Valve is used, do not use the adjustable Relief Assembly. Use the No- Relief Assembly.

Selector Valve (Accessory Equipment)

The Mainframe Swing, Moldboard Pivot and Tilt are fully hydraulic. All three Cylinders can be operated from two remote outlets. Below is a schematic diagram showing proper routing of two Cylinders through the Selector Valve. When installing this Valve, observe all safety precautions as hydraulic lines are under high pressure (2500 PSI). If additional information is required concerning your hydraulic system, contact your Rhino dealer.

ASSEMBLY

2500 01/11

Assembly Section 3-5

© 2011 Alamo Group Inc.

Image 29

Contents Rear Mounted Blade 2500To the Owner/Operator/Dealer Table of Contents Lubrication Proper Torque For Fasteners Safety Section Safety Messages Safety2500 01/11 Safety Section Safety Safety Safety S3PT-02 See Your Rhino Dealer Decal Location QTY Level Description Decal Description Safety Safety Safety Safety Federal Laws and Regulations Introduction Section Introduction IntroductionIntroduction Before Operating this Machine Assembly Section Assembly of Moldboard to Mainframe AssemblyAsm-0001 Hydraulic System Gauge Wheel Extra EquipmentSkid Shoes & Quick Tack End Plates Extra Equipment Hydraulic Control Valve Extra Equipment Selector Valve Accessory EquipmentPage Operation Section Operation Operation Standard Equipment and SpecificationsPersonal Protective Equipment PPE Operator RequirementsRops and Seat Belt Tractor HorsepowerTractor Requirements Tractor 3-Point Hitch Front End WeightGetting on and OFF the Tractor Dismounting the Tractor Boarding the TractorStarting the Tractor Connecting the Rear Blade to the TractorConnecting the Rear Blade Tractor Pre-Operation Inspection/Service PRE-OPERATION Inspection and ServiceBlade Pre-Operation Inspection/Service Do not Operate an Unsafe Tractor or Mower Do not Operate an Unsafe Tractor or Implement Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock SettingDriving the Tractor and Blade Operating the Tractor and ImplementDitching V-Type Ditch Operating the BladeShutting Down the Implement Disconnecting the Blade from the TractorTransporting the Tractor and Implement Blade StorageTransporting on Public Roadways Operation Hauling the Tractor and Implement Operation Problem Possible Cause Remedy Troubleshooting GuideMaintenance Section Lubrication MaintenanceProper Torque For Fasteners Rhino RhinoTo the OWNER/OPERATOR/DEALER SOM-01/11 00767428C Printed U.S.A