Alamo 2500 manual Starting the Tractor, Brake and Differential Lock Setting

Page 45

OPERATION

8.1 Starting the Tractor

The procedure to start the tractor is model specific. Refer to the tractor operator’s manual for starting procedures for your particular tractor. Consult an authorized dealer if the starting procedure is unclear. Ensure the 3-point control lever is in the lowered position and the PTO is disengaged before starting the tractor. OPS-U-0033

8.2 Brake and Differential Lock Setting

Make sure the tractor brakes are in good operating condition. Tractor brakes can be set to operate independently allowing single rear wheel braking action or locked together to provide simultaneous rear wheel braking. FOR MOST DRIVING AND OPERATING CONDITIONS, THE BRAKE PEDALS SHOULD BE LOCKED TOGETHER TO PROVIDE THE MOST EFFECTIVE BRAKING ACTION.

Always disengage the tractor differential lock when turning. When engaged the differential lock will prevent or limit the tractor from turning. During normal cutting conditions, locking the differential provides no benefit and should not be used. OPS- U- 0013

Be aware of the operating conditions. Do not operate the Tractor with weak or faulty brakes. When operating down a hill or on wet or rain slick roads, the braking distance increases; use extreme care and reduce your speed in these conditions. When operating in traffic, always use the Tractor’s flashing warning lights and reduce your speed. Be aware of traffic around you and watch out for the other guy.

2500 01/11

Operation Section 4-15

© 2011 Alamo Group Inc.

OPERATION

Page 44 Page 46
Image 45
Page 44 Page 46
Contents Rear Mounted Blade 2500To the Owner/Operator/Dealer Table of Contents Lubrication Proper Torque For Fasteners Safety Section Safety Messages Safety2500 01/11 Safety Section Safety Safety Safety S3PT-02 See Your Rhino Dealer Decal Location QTY Level Description Decal Description Safety Safety Safety Safety Federal Laws and Regulations Introduction Section Introduction IntroductionIntroduction Before Operating this Machine Assembly Section Assembly of Moldboard to Mainframe AssemblyAsm-0001 Gauge Wheel Extra Equipment Skid Shoes & Quick Tack End Plates Extra EquipmentHydraulic System Hydraulic Control Valve Extra Equipment Selector Valve Accessory EquipmentPage Operation Section Operation Operation Standard Equipment and SpecificationsPersonal Protective Equipment PPE Operator RequirementsTractor Horsepower Tractor RequirementsRops and Seat Belt Front End Weight Getting on and OFF the TractorTractor 3-Point Hitch Dismounting the Tractor Boarding the TractorStarting the Tractor Connecting the Rear Blade to the TractorConnecting the Rear Blade Tractor Pre-Operation Inspection/Service PRE-OPERATION Inspection and ServiceBlade Pre-Operation Inspection/Service Do not Operate an Unsafe Tractor or Mower Do not Operate an Unsafe Tractor or Implement Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock SettingDriving the Tractor and Blade Operating the Tractor and ImplementDitching V-Type Ditch Operating the BladeShutting Down the Implement Disconnecting the Blade from the TractorTransporting the Tractor and Implement Blade StorageTransporting on Public Roadways Operation Hauling the Tractor and Implement Operation Problem Possible Cause Remedy Troubleshooting GuideMaintenance Section Lubrication MaintenanceProper Torque For Fasteners Rhino RhinoTo the OWNER/OPERATOR/DEALER SOM-01/11 00767428C Printed U.S.A
Top Page Image Contents