h)Remove jack stands (or equivalent support) and lower deck to ground.
FIG. 6
BLADE BOLT INSTALLATION
5.1.4Check safety interlock system. Service Interval: Daily
a)For your safety, your Exmark mower is equipped with Operator Presence Controls (OPC). When either the mower blades are engaged, or the speed control lever is not in neutral and both hands are removed from the handles, the mower engine MUST stop.
b)Check OPC circuits. Clear the area. Run engine at
MUST stop.
Again, run engine at
c)If machine does not pass any of these tests, DO NOT operate. Contact your authorized EXMARK SERVICE DEALER.
IMPORTANT: It is essential that all Operator Safety Mechanisms be connected and in proper operating condition prior to the use of the mower.
5.1.5Check for loose hardware. Service Interval: Daily
a)Stop engine and remove spark plug wire(s).
b)Visually inspect machine for any loose hardware or any other possible problem. Tighten hardware or correct the problem before operating.
5.1.6Service
5.1.7Change engine oil.
Service Interval: See Engine Owner's Manual
NOTE: Change oil after first five (5) hours of operation. Follow engine manufacturers recommendations for future oil changes.
a)Disengage blade clutch.
b)Stop engine and remove spark plug wire(s).
c)Drain oil while engine is warm from operation.
- 19 -