Linn Akurate Kontrol Pre-Amplifier Selection Timeout, Startup Source, Standby Record from, Knekt

ENGLISH

SELECTION TIMEOUT

Set the time the AKURATE KONTROL takes to select a source when the source is changed.

Range: 1 SEC. to 10 SEC.

Default setting: 2 SEC.

STARTUP SOURCE

Set the source the AKURATE KONTROL selects when brought out of standby.

Options: LAST USED, NONE, (any of the source inputs)

Default setting: LAST USED

STANDBY RECORD FROM

You can record from a source component to a recording device through the AKURATE KONTROL, even if the AKURATE KONTROL is in standby mode.* Set which source you want the AKURATE KONTROL to select when it is in standby.

Options: LAST USED, NONE, (any of the sources), KNEKT**

Default setting: LAST USED

*For information on setting-up a record path see Record function, page 23.

**Is only available when KNEKT (see below) is set to LOCAL ROOM.

KNEKT

If your AKURATE KONTROL is installed in a Linn KNEKT multi-room system, select the appropriate setting. If your AKURATE KONTROL is not installed in a KNEKT system, select NONE.

Options: NONE, MAIN ROOM, LOCAL ROOM, INTERSEKT

Default setting: NONE

RCU/IR SOCKET

Define the use of the socket marked RCU on the back panel.

Options: RCU* (KNEKT Room Control Unit), IR (Infrared Repeater)

Default setting: RCU

* For use with Linn KNEKT systems only.

PRODUCT IR

Enable or disable the infrared receiver on the front of the unit.

Options: ENABLED, DISABLED

Default setting: ENABLED

RS232 SETUP

Accesses the RS232 SETUP sub-menu.

The RS232 Setup sub-menu is for use if the AKURATE KONTROL is communicating with other RS232 enabled products (e.g. a third-party controller).

BAUD RATE

Set the baud rate to suit the RS232 protocol being used.

Range: 4800 to 230400 (9 settings)

Default setting: 9600

PARITY

Set parity to suit the RS232 protocol being used.

Options: EVEN, ODD, NONE

Default setting: EVEN

DATA BITS

Set the data bits to suit the RS232 protocol being used.

Options: 7, 8

Default setting: 7

12AKURATE KONTROL