Linn Akurate Kontrol Pre-Amplifier owner manual

ENGLISH

7.Enter User Options on your UNIDISK player. Set –

Front Panel IR Commands to IGNORED or OFF Baud Rate to 9600

RS232 Events/Enable RS232 Events to ENABLED or ON (Also, for a UNIDISK SC set Knekt Mode to SOURCE.)

8.Exit User Options.

9.Enter the Speaker setup menu on the AKURATE KONTROL. Configure the menu as appropriate for the loudspeakers in your system.

10.Enter Source setup. Set the source inputs you wish to use for the UNIDISK to NONE. Save settings.

11.Enter the General setup menu.

12.Enter the RS232 Setup sub-menu. Set –

Baud Rate to 9600 Parity to EVEN Data Bits to 7 Stop Bits to 1

RS232 Events to (either setting) Save settings.

13.Enter the Linn Disc setup menu and change the ANALOG SOURCE and DIGITAL SOURCE settings as appropriate (see Linn Disc setup, page 13).

14.Enter the Source setup menu. Select the back panel input(s) used for the UNIDISK player and adjust the SAT SOURCE and SURROUND CHANNELS settings as required (see SAT SOURCE and SURROUND CHANNELS, page 9).

Save settings and exit setup.

16AKURATE KONTROL