Fuse replacement

ENGLISH

16.Power sources. Connect the apparatus to a power supply only of the type described in the operating instructions or marked on the apparatus.

17.Mains plug. Use the mains plug to disconnect the apparatus from the mains supply. The mains plug must be accessible at all times. Use the mains switch (if applicable) when the apparatus is not in use.

18.Power lines. An outdoor antenna should be located away from power lines.

19.Outdoor antenna grounding. If an outdoor antenna is connected to the apparatus, ensure that the antenna system is grounded to provide some protection against voltage surges and static build up. In the USA see article 810 of the National Electrical Code ANSI/NFPA 70 concerning installation requirements.

20.Telephone line. Do not connect the apparatus to a telephone line except where specifically instructed to do so.

21.Objects and liquid entry. Do not let objects or liquids fall into the apparatus. Do not expose the apparatus to dripping or splashing. Do not place a vessel containing liquid on top of the apparatus.

22.No naked flame sources, such as lighted candles, should be placed on the apparatus.

23.The apparatus has been designed for use in moderate and tropical climates.

UK USERS PLEASE READ THIS IMPORTANT SAFETY INFORMATION

This appliance is fitted with a non-rewireable 13 amp mains plug. The plug contains a 5 amp fuse. If the fuse has blown it can be replaced as follows:

a)Pull out the red fuse cover/carrier.

b)Remove and dispose of the blown fuse.

c)Fit a new 5 amp BS1362 approved fuse into the carrier and push the carrier back into the plug.

Always ensure the fuse cover is fitted. If the fuse cover is missing do not use the plug. Contact your Linn retailer to obtain a replacement fuse cover.

Fuses are for fire protection and do not protect against electric shock.

Mains plug replacement

Should your mains plug need replacing and you are competent to do this proceed as follows. If you are in doubt contact your Linn retailer or a competent electrician.

a)Disconnect the plug from the mains supply.

b)Cut off the plug and dispose of it safely. A plug with bared conductors is dangerous if engaged in a live socket.

c)Only fit a 13 amp BS1363A approved plug with a 5 amp fuse.

d)The cable wire colours or a letter will be marked at the connection points of most quality plugs.

Attach the wires securely to their respective points. The Brown wire must go to the Live pin, the Blue wire must go to the Neutral pin, and the Green/Yellow wire must go to the Earth pin.

e)Before replacing the plug top ensure that the cable restraint is holding the outer sheath of the cable firmly and that the wires are correctly connected.

WARNING

THIS APPLIANCE MUST BE EARTHED.

iiAKURATE KONTROL