Exmark Lawn Tractor manual There is no rollover protection when the roll bar is down

Page 11

WARNING

POTENTIAL HAZARD

There is no rollover protection when the roll bar is down.

WHAT CAN HAPPEN

Wheels dropping over edges, ditches, steep banks, or water can cause rollovers, which may result in serious injury, death or drowning.

HOW TO AVOID THE HAZARD

Keep the roll bar in the raised and locked position and use seat belt.

Lower the roll bar only when absolutely necessary.

Do not wear seat belt when the roll bar is down.

Drive slowly and carefully.

Raise the roll bar as soon as clearance permits.

Be certain that the seat belt can be released quickly if the machine is driven or rolls into ponds of water.

Check carefully for overhead clearances (i.e. branches, doorways, and electrical wires) before driving under any objects and do not contact them.

1.4.6Use EXTREME caution when backing up. LOOK BEHIND YOU!

1.4.7Stop the blades when crossing surfaces other than grass and when transporting the mower to and from the area to be mowed.

1.4.8Never operate the mower with damaged guards, shields, or covers. Always have safety shields, guards, switches, and other devices in place and in proper working condition.

1.4.9DO NOT change the engine governor settings or overspeed the engine. Operating an engine at excessive speed may increase the hazard of personal injury.

1.4.10Disengage PTO before starting engine.

1.4.11Start the engine carefully with feet well away from the blades.

1.4.12Keep hands, feet, and clothing away from rotating parts while the mower is being operated.

1.4.13Stop engine, wait for all moving parts to stop, and remove key:

Before checking, cleaning or working on the mower.

After striking a foreign object (inspect the mower for damage and make repairs before restarting and operating the mower).

Before clearing blockages.

Whenever you leave the mower.

Stop the engine and wait for all moving parts to stop:

Before refueling.

Before dumping the grass catcher.

1.4.14Before stopping the engine, place the throttle control midway between the “slow” and “fast” positions. Allow the engine to run a minimum of 15 seconds; then stop the engine.

1.4.15The fuel system is provided with a shut-off valve. Shut off the fuel:

When the machine will not be used for a few days.

During transport to and from the job.

When parked inside a building.

1.4.16This mower was designed for one operator only. Keep all others away from mower during operation.

-6 -

Image 11
Contents For Serial Nos 540,000 & Higher Potential Hazard Exmark Parts PLUS→ Program Operators Manual Table of Contents Preparation Safety Alert SymbolTraining Carbon monoxide can kill you Potential Hazard Operation Safe Zone for Mowing There is no rollover protection when the roll bar is down Maintenance and Storage Safety Signs Page Page Electrical System Specifications Model NumberEngine Fuel SystemCutting Deck Hydrostatic Ground Drive SystemTires Torque Requirements DimensionsUncrate Mower Install Rollover Protection System Roll BAR Lower Roll BAR Installation Machine is shipped with a filled lead acid battery Service BatteryUpper Roll BAR Installation Charging the battery may produce explosive gasses Check Tire Pressure Install Drive WheelsInstall Seat Install Motion Control LeversMotion Control Positions Service Engine Service Hydraulic OILPosition Discharge Chute ControlsPush the lever forward and down to disengage the brake Operating Instructions PRE-STARTStarting Engine Transporting Service Interval Daily Periodic MaintenanceService Interval Daily or more often in dry conditions Service Interval MonthlyService Interval Daily Blade Bolt Installation Service Interval 100 hrs Service Interval Refer to chart Service Interval 40 hrService Interval 40 hrs Caster Wheel Assembly Lubrication ChartService Interval Once Yearly Service Interval 80 hrs Service Interval 160 hrsService Interval 500 hrs Service Interval As RequiredService Interval After First 250 hrs Then yearly thereafter Cutting Height Position AdjustmentsANTI-SCALP Roller Adjustment Self-tensioning No adjustment necessary Swivel Adjustment Spring Compression AdjustmentBelt Guide Positioning Mule Drive Belt AdjustmentThrottle Tension Brake AdjustmentNo adjustment necessary Reverse Indicator Adjustment Motion Control Adjustment Motor OIL Disposal Battery DisposalCaster Adjustment Armrest AdjustmentEngine will not Start Mower Cuts UnevenlyProblem Engine Troubleshooting TableElectrical Diagram Hydraulic Diagram Year Limited Warranty Service Record Page See EXMARK’S Complete Line of Accessories