Ferris Industries Ferris Hydraulic Oil Change and Maintenance for Lawn Mowers: Oil Capacity and Filter Guide

Page 30

Maintenance

Regular Maintenance

CHECK HYDRAULIC OIL LEVEL

1.Before removing the reservoir cap, make sure the area around the reservoir cap and fill neck of the reservoir is free of dust, dirt, or other debris.

2.Unscrew the reservoir cap (B, Figure 20).

3.Look down the filler neck of the hydraulic oil reservoir (A, Figure 20) and observe the oil level. When cold, the oil level should be approximately 4” (10 cm) below top of the filler neck.

4.If necessary, add either Mobil 1™, 15W-50 synthetic oil or Castrol Syntec™ 5W-50 oil. DO NOT use conventional oils.

5.Reinstall the reservoir cap.

CHANGE HYDRAULIC OIL FILTER

Change Interval: Every 250 Hours

Filter Part Number: 1719168

NOTE: Removing the oil filter from the filter base will drain the oil reservoir. Have a suitable container ready to catch any spilled oil. Ferris recommends this be a dealer-only service item.

1.Locate the transmission oil filter (E, Figure 21) at the rear of the battery compartment under the seat.

2.Lubricate the new filter base with a few drops of transmission oil. Fill the filter half full of oil.

3.Clean the area around the filter base and remove the filter. Do NOT drain the hydraulic system oil.

4.Thread the new filter onto the filter base until the gasket makes contact, then tighten 3/4 of a turn more.

5.Run the unit for several minutes and check the transmission oil level.

IMPORTANT NOTE: Use caution after changing the filter; air in the hydraulic system may affect the responsiveness of the control levers. Repeat step 5 until the air is out of the system.

BATTERY MAINTENANCE

NOTE: This unit is equipped with a maintenance-free BCIU1 battery.

Cleaning the Battery and Cables

1.Remove the hydraulic oil reservoir mounting hardware (C, Figure 21) and move the reservoir

(D) forward to expose the battery.

2.Disconnect the cables from the battery, negative (black) cable first (B).

3.Clean the battery terminals and cable ends with a wire brush until shiny.

4.Reinstall the battery and reattach the battery cables, positive (red) cable first (A).

5.Coat the cable ends and battery terminals with petroleum jelly or non-conducting grease.

6.Reposition the oil reservoir and secure in place with the hardware previously removed.

28

B

A

Figure 20. Checking Hydraulic Oil Level

A.Hydraulic Oil Reservoir

B.Reservoir Cap

D

C

A

C

E

B

Figure 21. Battery Compartment

A.Positive (+) Cable & Terminal

B.Negative (-) Cable & Terminal

C.Reservoir Mounting Hardware

D.Hydraulic Oil Reservoir

E.Hydraulic Oil Filter

WARNING

Be careful when handling the battery. Avoid spilling electrolyte. Keep flames and sparks away from the battery.

When removing or installing battery cables, disconnect the negative cable FIRST and reconnect it LAST. If not done in this order, the positive terminal can be shorted to the frame by a tool.

www.ferrisindustries.com

Image 30
Contents Description Model NumberFerris Industries Date Purchased Table of Contents Operating Safety Safety Rules & InformationSlope Operation Roll Bar Use Fuel and Maintenance Operation TrainingPreparation Children Slope OperationTowed Equipment RIDE-ON Units EmissionsService and Maintenance Maintenance and StorageSafe Handling of Gasoline Roll BAR Instructions Operational WarningsInspection and Maintenance of the Roll BAR Seat Belt Identification Numbers IdentificationSafety Decals Safety DecalsSafety Interlock System North American Safety IconsOperational Safety Checks Ignition Switch Features & ControlsSeat Adjustment Lever Control FunctionsParking Brake PTO Power Take Off SwitchHour Meter / Maintenance Reminder Throttle ControlGeneral Operating Safety OperationChecks Before Starting Starting the Engine Stopping the RiderPushing the Rider by Hand Forward Travel Practice Zero Turn Driving PracticeSmooth Travel Reverse Travel PracticePractice Turning Around a Corner Practice Turning In Place Executing an End-Of-Row Zero TurnHeight of Grass MowingMowing Recommendations Tall Grass Requires Incremental CuttingMowing Patterns When and How Often to MowMowing Methods Proper Broadcast MowingAttaching a Trailer Proper MulchingTo raise the roll bar Raise & Lower the Roll BARTo lower the roll bar Keep roll bar in the raised position and use seat beltTemporary Storage 30 Days Or Less StorageStarting After Long Term Storage Long Term Storage Longer Than 30 DaysEngine Maintenance Safety ItemsRider Maintenance Check Tire PressuresChecking / Adding Fuel Regular MaintenanceEngine Maintenance Fuel FilterLubrication GreaseOil Check Hydraulic OIL Level Battery MaintenanceCleaning the Battery and Cables Change Hydraulic OIL FilterServicing the Mower Blades Removing the BladeTroubleshooting Troubleshooting the RiderTroubleshooting, Adjustment & Service Troubleshooting the MowerTroubleshooting, Adjustment & Service Troubleshooting Common Cutting ProblemsSeat Adjustment Ground Speed Control Lever AdjustmentSpeed Balancing Adjustment Parking Brake Adjustment Parking Brake Adjustment Brake Spring Adjustment NutRear Suspension Adjustment To adjust the spring pre-loadTo adjust the upper mounting position PTO Clutch Adjustment Blade Brake CheckRETURN-TO-NEUTRAL Adjustment Neutral AdjustmentMowing Height Adjustment Foot Pedal AdjustmentTo adjust pedal position Deck Leveling Adjustment Check Lift Rod TimingHydraulic Pump Drive Belt Replacement Mower Belt Replacement Mower PTO Belt Idler Arm Stationary Idler PulleyCharging a Completely Discharged Battery Battery ServiceChecking Battery Voltage Jump Starting With Auxiliary Booster BatteryThis HOOK-UP for Negative Ground Vehicles Make Certain Vehicles do not TouchEngine SpecificationsDimensions ChassisFerris Limited Warranty Belts and Blades TractorMower Deck