RAISE & LOWER THE ROLL BAR
To lower the roll bar:
1.Pull the hair pin clips (A, Figure 13) out of the retainer pins (B).
2.Push or pull the top of the roll bar (C) forward against the rubber stops (D) and remove the retainer pins (B).
3.Lower the roll bar and reinstall the retainer pins and hair pin clips to secure the roll bar in the down position (see insert, Figure 13).
To raise the roll bar:
1.Pull the hair pin clips (A) out of the retainer pins
(B) and remove the retainer pins.
2.Raise the roll bar (C) until the rubber stops (D) contact the upright tubes.
3.Push or pull the top of the roll bar forward against the rubber stops and reinstall the retainer pins and hair pin clips to secure the roll bar in the raised position.
WARNING
AVOID SERIOUS INJURY OR DEATH FROM ROLL OVER:
Keep roll bar in the raised position and use seat belt.
THERE IS NO ROLL OVER PROTECTION WHEN THE ROLL BAR IS DOWN
Lower the roll bar only when necessary and NEVER remove it.
Do NOT use seat belt when the roll bar is down.
Raise the roll bar as soon as clearance permits.
Do NOT jump off if mower tips.
| Operation |
C | D |
| |
| C |
| A |
B | D |
Figure 13. Raise & Lower the Roll Bar
A.Hair Pin Clip
B.Retainer Pin
C.Roll Bar
D.Rubber Stop
Operation
23