Ferris Industries 5900761, 5900751 manual Engine, Chassis, Transmissions, Dimensions

Page 48

Specifications

NOTE: Specifications are correct at time of printing and are subject to change without notice.

ENGINE:

28 HP Briggs & Stratton

Make

Briggs & Stratton

Model

541777-0110-E1

Horsepower

28 @ 3600 rpm

Displacement

54.68 Cu. in (896 cc)

Electrical System

12 Volt, 20 amp. Alternator, Battery: 340

 

CCA

Oil Capacity

2.4 qt. (2.25 L) w/ Filter

CHASSIS:

Fuel Tank

Capacity: 6 Gallons (22,7 L) Total

Rear Wheels

Tire Size: 22 x 11.00 -10 (61” Deck)

 

Inflation Pressure: 15 psi (1,03 bar)

Front Wheels

Tire Size: 13 x 5.00 - 6

 

Inflation Pressure: 25 psi (1,72 bar)

TRANSMISSIONS:

HydroGear PJ-3H / HGM-15E 3138

Type

Pump and Wheel Motor

Hydraulic Fluid

Mobil 1™ 15W-50 synthetic oil or

 

Castrol Syntec™ 5W-50 oil

Speeds

Forward: 0-10 MPH (0-16.09 km/h)

@ 3400 rpm

Reverse: 0-5 MPH (0-8.05 km/h)

Continuous Torque

222 ft. lbs. (301 N.m.)

Output

 

Maximum Weight

750 lbs. (340 Kg)

on Axle

 

DIMENSIONS:

Overall Length

81” (208 cm)

Overall Width

72” (183 cm) - 61” Deck

Height

70” (178 cm) with Roll Bar Up

 

59” (150 cm) with Roll Bar Down

Weight (apx..)

 

With 61” Mower Deck

1222 lbs. (554 kg)

Engine Power Rating Information

The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive Engineers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained and corrected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower values are derived at 3600 RPM. Actual gross engine power will be lower and is affected by, among other things, ambient operating conditions and engine-to-engine variability. Given both the wide array of products on which engines are placed and the variety of environmental issues applicable to operating the equipment, the gas engine will not develop the rated gross power when used in a given piece of power equipment (actual "on-site" or net power). This difference is due to a variety of factors including, but not limited to, accessories (air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-engine variability. Due to manufacturing and capacity limitations, Briggs & Stratton may substitute an engine of higher rated power for this Series engine.

Specifications

46

www.ferrisindustries.com

Image 48
Contents Briggs & Stratton Power Products Group, LLC DescriptionModel Number Date Purchased Table of Contents Operating Safety Slope Operation Roll Bar Use Fuel and Maintenance Operation TrainingPreparation Slope Operation Towed Equipment RIDE-ON UnitsChildren EmissionsService and Maintenance Ignition System Gasoline ModelsRoll BAR Instructions Operational WarningsInspection and Maintenance of the Roll BAR Seat Belt Identification Numbers IdentificationSafety Decals Safety Interlock System North American Safety IconsOperational Safety Checks Seat Adjustment Lever Ignition SwitchControl Functions Ground Speed Control LeversPTO Power Take Off Switch Hour Meter / Maintenance ReminderParking Brake Throttle ControlGeneral Operating Safety Checks Before StartingStarting the Engine Stopping the RiderPushing the Rider by Hand Zero Turn Driving Practice Smooth TravelForward Travel Practice Reverse Travel PracticePractice Turning Around a Corner Practice Turning In Place Executing an End-Of-Row Zero TurnExecuting Turns TurningMowing Mowing RecommendationsHeight of Grass Tall Grass Requires Incremental CuttingWhen and How Often to Mow Mowing MethodsMowing Patterns Proper Broadcast MowingAttaching a Trailer Proper MulchingRaise & Lower the Roll BAR To lower the roll barTo raise the roll bar Keep roll bar in the raised position and use seat beltStorage Starting After Long Term StorageTemporary Storage 30 Days Or Less Long Term Storage Longer Than 30 DaysSafety Items Rider MaintenanceEngine Maintenance Before Every Spring Each 100 250 Fall Use HoursCheck Tire Pressures Checking / Adding FuelFuel Filter Change OIL & FilterCheck Hydraulic OIL Level Change Hydraulic OIL FilterChange Interval Every 250 Hours Filter Part Number Lubrication GreaseOil Lubricating the Front CastersBattery Maintenance Cleaning the Battery and Cables Air Cooled ModelsServicing the Mower Blades Removing the Mower BladeInspecting the Mower Blades Reinstalling the Mower Blades Sharpening the Mower BladeBalancing the Mower Blades Troubleshooting Warning Troubleshooting the RiderTroubleshooting the Mower Rider TroubleshootingTroubleshooting Common Cutting Problems StreakingSeat Adjustment Ground Speed Control Lever AdjustmentSpeed Balancing Adjustment Neutral Adjustment RETURN-TO-NEUTRAL AdjustmentAdjustment Linkage Rod RH side shownParking Brake Adjustment Parking Brake Adjustment Brake Spring Adjustment NutRear Suspension Adjustment To adjust the spring pre-loadTo adjust the upper mounting position Mowing Height Adjustment Foot Pedal AdjustmentTo adjust pedal position Deck Lift ROD Timing Adjustment Check Lift Rod TimingDeck Leveling Adjustment Deck Lift SpringHydraulic Pump Drive Belt Replacement Mower Belt Replacement Mower PTO Belt Idler Arm Stationary Idler PulleyBattery Service Checking Battery VoltageCharging a Completely Discharged Battery Jump Starting With Auxiliary Booster BatteryThis HOOK-UP for Negative Ground Vehicles Make Certain Vehicles do not TouchJump Starting Dimensions EngineChassis TransmissionsFerris Limited Warranty Belts and Blades TractorMower Deck

5900761, 5900751 specifications

Ferris Industries has long been recognized for its innovative approach to outdoor power equipment, and the models 5900751 and 5900761 exemplify this commitment to quality and performance. With features tailored for both residential and commercial use, these products showcase advanced technologies that enhance user experience and operational efficiency.

The Ferris Industries 5900751 model stands out with its robust build and powerful engine, designed to tackle a variety of mowing tasks effortlessly. This model is equipped with a reliable commercial-grade engine that provides ample power to tackle even the most challenging terrains. The cutting deck, optimized for superior grass clipping management, ensures a clean and even cut, making it ideal for maintaining professional-looking lawns.

Similarly, the 5900761 brings its own unique set of features that make it a formidable choice for larger properties or commercial settings. One of its standout characteristics is the durable construction that helps resist wear and tear over time. With a larger cutting deck and an efficient powertrain, this model is designed to cover more ground in less time, boosting productivity significantly.

Both models incorporate Ferris's patented suspension technology. The advanced suspension system reduces operator fatigue, allowing for longer mowing sessions with greater comfort. This technology also improves traction and stability on uneven surfaces, ensuring a smoother ride regardless of the landscape.

In terms of technology, both the 5900751 and 5900761 feature user-friendly controls that enhance maneuverability. The intuitive dashboard displays vital information, providing operators with insights into performance metrics at a glance. Additionally, the ease of maintenance is a focal point, with accessible components that streamline service tasks, ensuring that downtime is minimized.

The ergonomic design of the handles and seat enhances user comfort and control, allowing for effortless navigation around obstacles. Safety features such as a reliable braking system and roll-over protection further ensure that operators can work with confidence.

In summary, Ferris Industries models 5900751 and 5900761 are powerful and efficient solutions for anyone looking to invest in reliable outdoor power equipment. With their durable design, advanced suspension technology, and user-focused features, these models continue to set the standard for excellence in the industry. Whether for personal use or professional landscaping, Ferris delivers equipment that meets the demands of any task with exceptional performance.