Ferris Industries DDSKAV23CE, DDSKAV15CE Regular Maintenance, Checking / Adding Fuel, Fuel Filter

Page 17

CHECKING / ADDING FUEL

To add fuel:

1.Remove the fuel cap (see A, Figure 2).

2.Fill the tank to the bottom of the filler neck. This will allow for fuel expansion.

NOTE: Do not overfill. Refer to your engine manual for specific fuel recommendations.

3.Install and hand tighten the fuel cap.

4.Repeat same process for opposite tank.

FUEL FILTER

The fuel filter (D, Figure 2) is located in the fuel line between fuel shut off valve and carburetor, near the fuel pump. If filter is dirty or clogged, replace as follows:

1.Shut off the fuel tank selection valve.

2.Disconnect the negative battery cable.

3.Place a container below the filter to catch spilled fuel.

4.Using a pliers, open and slide hose clamps from fuel filter.

5.Remove hoses from filter.

6.Install new filter in proper flow direction in fuel line.

7.Secure with hose clamps.

8.Reconnect the negative battery cable when finished.

OIL & FILTER CHANGE

Refer to engine owners manual.

CHECK / CHANGE AIR FILTER

Refer to engine owners manual.

REPLACE SPARK PLUG

Refer to engine owners manual.

CHECK HYDRAULIC OIL LEVEL

1.Observe the oil reservoirs (B, Figure 2). The oil level should be at the “FULL” line (C, figure 2).

2.Before removing the reservoir caps, make sure the area around the reservoir cap is free of dust, dirt, or other debris.

3.If necessary, unscrew the reservoir cap and add SAE straight 20 or 30 weight motor oil. DO NOT use multi-grade oils. Fill until oil level reaches “FULL” line.

4.Reinstall oil reservoir caps.

Regular Maintenance

WARNING

Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is still hot from recent operation. Do not allow open flame, smoking or matches in the area. Avoid over-filling and wipe up any spills.

Do not remove fuel filter when engine is hot, as spilled gasoline may ignite. DO NOT spread hose clamps further than necessary. Ensure clamps grip hoses firmly over filter after installation.

Do not use gasoline containing METHANOL, gasohol containing more than 10% ethanol, gasoline additives, premium gasoline, or white gas because engine/fuel system damage could result.

 

A

 

B

 

C

 

D

Figure 5.

Fuel Tank, Oil Reservoir & Fuel Filter

A.Fuel Cap

B.Oil Reservoirs

C.“FULL” Line

D.Fuel Filter

15

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Mower Decks PowerheadsDescription Ferris IndustriesFERRISFerris Industries Ferris Limited WarrantyTable of Contents CE Models Identification NumbersNorth American Models Preparation TrainingOperation Safety Rules & InformationSlope Operation Do NotEmissions Maintenance and StorageChildren Dash Panel Decal Safety DecalsGeneral CE Compliance Specs Forward Speed Control Lever / Reverse Speed Control Levers Ignition SwitchControl Functions Safety Interlock System Features & ControlsChecks Before Starting General Operating SafetyStopping the Mower Starting the EngineDriving the Mower To make a left-hand turnPushing the Mower by Hand Operating the Dual Drive Walk-BehindMowing Starting After Long Term Storage StorageTemporary Storage 30 Days Or Less Long Term Storage Longer Than 30 DaysSee Before Every Spring Check Tire PressuresFall Tire PressureChecking / Adding Fuel Regular MaintenanceFuel Filter Fuel Tank, Oil Reservoir & Fuel FilterMotion Control Pivot & Rod Pivot LubricationCleaning the Battery and Cables Battery MaintenanceChecking the Battery Fluid Removing the Blade Servicing the Mower BladesTroubleshooting the Mower Troubleshooting Adjustments & ServiceTroubleshooting the Mower Deck Troubleshooting, Adjustment & ServiceMount Blade Caster Height Of Cut Mowing Height AdjustmentDdsh Models only Deck Leveling AdjustmentShimming the Hanger Shafts Shim Assembly PositionSpindle Belt Mower Belt Replacement and AdjustmentPTO Clutch to Deck Belt Mower PTO Belt Transmission Drive Belt Transmission Drive Belt ReplacementNeutral Adjustment Transmission Neutral & Tracking AdjustmentsTracking Adjustment If Machine Veers to the LeftTo Bleed Air From Transmissions Transmission Maintenance and ServiceChanging Oil & Filters Blade Brake Check PTO Clutch AdjustmentChecking Battery Voltage Battery ServiceCharging a Completely Discharged Battery Jump Starting With Auxiliary Booster BatteryEngine Block Troubleshooting, Adjustment & ServiceAccessories Common Replacement Parts & AccessoriesCommon Replacement Parts Types of GRASS, Climate and Conditions HOW and When to WATER, Fertilize & AerateGeneral Information Tall Grass Requires Incremental Cutting Lawn Care & Mowing InformationInch Proper Cutting HeightWhat Mowing Patterns to USE When and HOW Often to MOWProper Mulching Mowing MethodsProper Broadcast Mowing Composting How to start a healthy compost pileTips On Dealing With Clippings Methods actually contribute to a healthy lawnStreaking Solutions for Common Mowing ProblemsStepped Cutting Stepped CuttingStingers Uneven CuttingScalping Choke Common International SymbolsTechnical Manuals LC-9

DDSKAV17CE, DDSKAV15CE, DDSKAV23CE specifications

Ferris Industries has long been a leader in the outdoor power equipment industry, known for delivering innovative and reliable solutions for landscaping and maintenance professionals. Among its impressive lineup, the Ferris DDSKAV23CE, DDSKAV15CE, and DDSKAV17CE stand out as robust and efficient models designed to meet the demanding needs of lawn care and agricultural operations.

The DDSKAV23CE is equipped with a powerful 23 horsepower engine that enhances performance across various terrains. One of its main features is the advanced suspension system, which allows for superior handling and comfort during use. This model also incorporates a state-of-the-art hydrostatic drive system, providing smooth and precise acceleration, making it an ideal choice for operators who require high maneuverability and control on uneven grounds.

The DDSKAV15CE offers a compact yet powerful option, boasting a 15 horsepower engine. This model is particularly designed for smaller properties or residential use, where agility and ease of operation are paramount. Its lightweight design does not compromise durability, allowing users to traverse tight spots effortlessly. The DDSKAV15CE also incorporates ergonomic controls for reduced operator fatigue during extended use.

On the other hand, the DDSKAV17CE blends power and efficiency with its 17 horsepower engine. This model features a larger cutting deck, which increases productivity by allowing the user to cover more ground in less time. The DDSKAV17CE is also equipped with enhanced traction capabilities, ensuring it can handle wet or hilly terrains without losing performance.

All three models utilize Ferris's patented iCD Cutting System, which provides a superior quality of cut and maintains a consistent performance even in challenging mowing conditions. The cutting decks are designed for easy maintenance and longevity, ensuring your investment can endure the rigors of frequent use.

Moreover, each model is built with rugged aluminum frame construction that enhances durability while reducing overall weight, further improving maneuverability and reducing operator fatigue.

In summary, Ferris Industries' DDSKAV23CE, DDSKAV15CE, and DDSKAV17CE models combine power, efficiency, and innovative technology, making them ideal solutions for landscaping professionals and property owners seeking reliable outdoor equipment. Their unique blend of features caters to varied landscape maintenance needs, ensuring they are equipped to handle the toughest tasks.
Top Page Image Contents