Hayter Mowers RT380H manual Setup, Loose Parts, Media and Additional Parts

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.

Procedure	Description			Qty.	Use
	Front wheels			2
1	Shim washers (as required)			2
	Flat washers			2	Install the front wheels.
	Cotter pins			2
	Hub caps			2
2	No parts required			–	Check the tyre pressure.
3	Steering wheel			1	Install the steering wheel.
	Spirol pin			1
4	Seat			1	Install the seat.
	Knobs			2
	Flat-washer			2
	Bulk electrolyte, 1.260 specific gravity			As
5	(purchase separately)			needed	Activate the battery.
	Bolt (1/4 x 3/4 inch)			2
	Wing nut			2
6	No parts required			–	Check the engine oil level.
7	Anti-scalp wheels			2
	Wheel bolt			2	Install the anti-scalp wheels.
	Locknut			2
8	No parts required			–	Preparing the cutter deck discharge
					chute.
9	No parts required			–	Lubricate the tractor.
10	No parts required			–	Check the safety interlock system.
11	No parts required			–	Purge the hydro transaxle,
12	No parts required			–	Check the hydro neutral position.
13	No parts required			–	Check the traction control pedal.
Media and Additional Parts
Description		Qty.			Use
Ignition key		1	Start the engine.
Reverse interlock key		1	Enable mowing operation in reverse.
Lift assist spring removal tool		1	Save for future maintenance use.
Operator’s Manual		1	Read before operating.
Certificate of Conformance		1	CE conformance
Noise certificate		1

10