•It cleans the engine while it runs.
•It eliminates
Important: Do not use fuel additives containing methanol or ethanol.
Add the correct amount of fuel stabilizer/conditioner to the petrol.
Note: A fuel stabilizer/conditioner is most effective when it is mixed with fresh petrol. To minimize the chance of varnish deposits in the fuel system, use a fuel stabilizer/conditioner at all times.
Filling the Fuel Tank
1.Set the parking brake.
2.Stop the engine, remove the key, and wait for all moving parts to stop before leaving the operating position.
3.Clean around the fuel tank cap and remove the cap.
4.Add unleaded petrol to the fuel tank until the level is 1/4 to 1/2 inch (6 to 13 mm) below the bottom of the filler neck. Do not fill the fuel tank completely full.
Note: The space in the tank allows petrol to expand.
5.Install the fuel tank cap securely.
6.Wipe up any petrol that spills.
Figure 14
1. Brake pedal | 2. Parking brake lever |
2.Lift the parking brake lever (Figure 14) up and gradually take your foot off of the brake pedal.
Note: The brake pedal should stay in the depressed (locked) position.
Releasing the Parking Brake
1.Push down on the brake pedal (Figure 14).
Note: The parking brake lever should release.
2.Gradually release the brake pedal.
Positioning the Seat
The seat can move forward and backward. Position the seat where you have the best control of the tractor and are most comfortable.
1.Raise the seat and loosen the adjustment knobs (Figure 15).
Checking the Engine Oil Level
Service Interval: Before each use or daily
Before you start the engine and use the tractor, check the oil level in the engine crankcase; refer to Checking the Engine Oil Level, in Maintenance.
Using the Parking Brake
Always set the parking brake whenever you stop the tractor or leave it unattended.
Setting the Parking Brake
1. Push the brake pedal (Figure 14) down and hold it.
Figure 15
1.Adjustment knobs
2.Move the seat to the desired position and tighten the knobs.
Operating the Headlights
A
18