7
Installing the Anti-Scalp Wheels
Parts needed for this procedure:
2
2Wheel bolt
2Locknut
9
Lubricating the Tractor
No Parts Required
Procedure
Ensure that all of the necessary points on the tractor are lubricated; refer to Greasing and Lubricating the Tractor in Maintenance.
Procedure
Mount the
|
| Figure 9 |
|
1. | Wheel | 3. | Locknut |
2. | Wheel bracket | 4. | Wheel bolt |
Note: Use the same hole height on both sides.
8
Preparing the Cutter Deck Discharge Chute
No Parts Required
Procedure
1.Remove the roll pin from the discharge chute spring and discard the pin.
Note: The roll pin is for shipment only
2.Ensure that the spring returns the discharge chute to the full down position.
10
Checking the Safety Interlock System
No Parts Required
Procedure
Check the safety interlock system; refer to Testing the Safety Interlock System in Operation.
11
Purging the Hydro Transaxle
No Parts Required
Procedure
Shipping and handling can introduce air into the hydro transaxle. For proper performance, remove all the trapped air.
1.Move the tractor to a flat, level surface
2.Place the drive control in the Push position (Figure 10).
14