Hayter Mowers RT380H manual Cooling System Maintenance, Cleaning the Cooling System

Page 33

Figure 42

1.Fill plug

5.Remove the fill plug and check the fluid level.

Note: The level should be a maximum of 1-1/4 inch (32 mm) below the top of the fill port (Figure 42). Add fluid if necessary.

6.Install the fill plug.

Cooling System

Maintenance

Cleaning the Cooling System

Service Interval: Every 100 hours

Use a dry brush to clean grass and accumulated debris from the engine daily.

Important: To prevent contaminating the fuel system, do not use water to clean the engine.

33

Image 33

Contents With Recycling/Side Discharge Deck RT380H TractorIntroduction ContentsSafety TrainingPreparation Mow only in daylight or in good artificial light OperationMaintenance and Storage Sound PowerSound Pressure VibrationSlope Chart 114-3236 Safety and Instructional Decals93-6677 107-4922 Setup Loose PartsMedia and Additional Parts Installing the Steering Wheel Installing the Front WheelsParts needed for this procedure No Parts Required ProcedureActivating the Battery Installing the SeatChecking the Engine Oil Level Wait 5 to 10 minutes after filling the battery cellsChecking the Safety Interlock System Installing the Anti-Scalp WheelsLubricating the Tractor Preparing the Cutter Deck Discharge ChuteChecking the Hydro Neutral Position Product Overview Checking the Traction Control PedalControls Using Stabilizer/Conditioner OperationPetrol and Oil Using the Parking Brake Positioning the SeatOperating the Headlights Engaging the Power Take Off PTO Setting the Height-of-CutOperating the Blade Control PTO Starting the EngineUnderstanding the Safety Interlock System Using the Safety Interlock SystemSetting the Tractor to Operate in Reverse Stopping the EnginePushing the Tractor Manually Testing the Safety Interlock SystemTo Push the Tractor To Operate the TractorDriving Forward or Backward Installing the Discharge CoverStopping the Tractor Side Discharge or Mulch GrassOperating Tips Recommended Maintenance Schedules MaintenanceLubrication Engine Maintenance Greasing and Lubricating the TractorServicing the Engine Oil Changing the Oil Servicing the Air CleanerChanging the Oil Filter Removing the Foam and Paper ElementsCleaning the Foam and Paper Elements Installing the Foam and Paper ElementsServicing the Spark Plug Removing the Spark PlugInstalling the Spark Plug Fuel System MaintenanceDraining the Fuel Tank Checking the Spark PlugServicing the Battery Electrical System MaintenanceRemoving the Battery Replacing the Fuel FilterInstalling the Battery Adding Water to the BatteryChecking the Electrolyte Level Servicing the Fuse Charging the BatteryServicing the Headlights Removing the BulbInstalling the Bulb Drive System MaintenanceServicing the Transaxle Fluid Checking the Fluid LevelCleaning the Cooling System Cooling System MaintenanceAdjusting the Parking Brake Brake MaintenanceServicing the Parking Brake Checking the Parking BrakeBelt Maintenance Cutter Deck Maintenance Replacing the Blade Drive BeltServicing the Blades Installing the Blades Removing the Cutter DeckSharpening the Blades Idler spring Idler arm Eye-bolt Installing the Cutter Deck Leveling the Cutter Deck from Side-to-Side Adjusting the Front-to-Rear Blade Slope Washing the Underside of the Cutter Deck CleaningStorage Cover the tractor to protect it and keep it clean Problem Possible Cause Corrective Action TroubleshootingTractor does not drive Schematics Page Page 1st Year 12 months Page Limited Warranty Date of Sale Your Local Dealer