Husqvarna 96045000408 owner manual To Adjust Steering Wheel Alignment, Front Wheel Toe-In/Camber

Page 22

TO ADJUST STEERING WHEEL ALIGNMENT

SERVICE AND ADJUSTMENTS

TO ADJUST STEERING WHEEL ALIGNMENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the factory set front wheel toe-in or camber, contact a qualified service center.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 28)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR

WHEEL ONLY)

FIG. 28

TO START ENGINE WITH A WEAK BATTERY (See Fig. 29)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

WEAK OR DEAD

FULLY CHARGED

BATTERY

BATTERY

FIG. 29

22

Image 22

Contents YTH20K46 Owners Manual / 96045000408I. GENERAL OPERATION SAFETY RULESSafe Operation Practices for Ride-On Mowers II. SLOPE OPERATIONIII. CHILDREN V. SERVICEIV. TOWING PRODUCT SPECIFICATIONS TABLE OF CONTENTSCUSTOMER RESPONSIBILITIES ADJUST SEAT See Fig ASSEMBLYTO CHECK BATTERY See Fig UNASSEMBLED PARTSCHECK FOR PROPER POSITION OF ALL BELTS CHECK TIRE PRESSURECHECK DECK LEVELNESS CHECK BRAKE SYSTEMOPERATION KNOW YOUR TRACTOR PH DG ESTOPPING See Fig. 5A HOW TO USE YOUR TRACTORTO SET PARKING BRAKE See Fig TO USE THROTTLE CONTROL D See Fig. BTO MOVE FORWARD AND BACKWARD See Fig TO ADJUST MOWER CUTTING HEIGHT See FigTO ADJUST GAUGE WHEELS See Fig TO USE CRUISE CONTROL J See FigTO OPERATE ON HILLS TO OPERATE MOWER See FigREVERSE OPERATION SYSTEM ROS See Fig TO TRANSPORT See Figs. 3 andCHECK ENGINE OIL LEVEL SERVICE REMINDER/HOUR METERBEFORE STARTING THE ENGINE ADD GASOLINEMOWING TIPS PURGE TRANSMISSIONMAINTENANCE LUBRICATION CHARTBLADE CARE BATTERYTRACTOR BLADE REMOVAL See FigTRANSAXLE COOLING ENGINEV-BELTS TRANSAXLE PUMP FLUIDCLEAN AIR SCREEN CLEANINGCLEAN AIR INTAKE/COOLING AREAS AIR FILTERTO REMOVE MOWER See Fig SERVICE AND ADJUSTMENTSTO INSTALL MOWER See Figs Q R AEE FJ H TO LEVEL MOWER TO CHECK BRAKE TO REPLACE MOWER BLADE DRIVE BELT See FigTO REPLACE MOTION DRIVE BELT See Fig FRONT WHEEL TOE-IN/CAMBER TO ADJUST STEERING WHEEL ALIGNMENTTO START ENGINE WITH A WEAK BATTERY See Fig TO REMOVE WHEEL FOR REPAIRS See FigTO ADJUST THROTTLE CONTROL CABLE REPLACING BATTERY See FigTO REMOVE HOOD AND GRILL ASSEMBLY See Fig TO ADJUST CARBURETORFUEL SYSTEM STORAGEOTHER ENGINE OILCAUSE TROUBLESHOOTING POINTSPROBLEM CORRECTIONEngine dies when IGNITION SWITCH SCHEMATICTRACTOR - - MODEL NUMBER YTH20K46 96045000408, PRODUCT NO. 960 45 SCH10TRACTOR - - MODEL NUMBER YTH20K46 96045000408, PRODUCT NO. 960 45 ELECTRICALWith Service Minder Option T04STRACTOR - - MODEL NUMBER YTH20K46 96045000408, PRODUCT NO. 960 45 CHASSIS TRACTOR - - MODEL NUMBER YTH20K46 96045000408, PRODUCT NO. 960 45 DRIVE drive-texT2pedal10DRIVE SPARK ARRESTER KIT ENGINEengine-texKohl7 TRACTOR - - MODEL NUMBER YTH20K46 96045000408, PRODUCT NO. 960 45 STEERING ASSEMBLY steering-texLEGND216STEERING ASSEMBLY WHEELS AND TIRES DECALSwheelart1-tex SEAT ASSEMBLY seat-tex6.5SL3MOWER DECK 46texltpred3r6TRACTOR - - MODEL NUMBER YTH20K46 96045000408, PRODUCT NO. 960 45 MOWER LIFT lift-tex6HUSQVARNA PRODUCT REGISTRATION INFORMATION & WARRANTY STATEMENT SECTION 6 PROCEDURE TO OBTAIN WARRANTY CONSIDERATION SECTION 2 HUSQVARNAS OBLIGATIONS UNDER THE WARRANTYSECTION 3 ITEMS NOT COVERED BY THIS WARRANTY SECTION 4 EXCEPTIONS AND LIMITATIONS532 42 20-50R1 07.30.08 AP Printed in the U.S.A