Husqvarna 532 42 20-50_R1, 96045000408 Unassembled Parts, Assembly, To Remove Tractor From Carton

Page 5

UNASSEMBLED PARTS

UNASSEMBLED PARTS

Slope Sheet

Key

(1) Oil Drain Tube

(2) Keys

ASSEMBLY

Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes.

When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

•Remove all accessible loose parts and parts cartons from carton.

•Cut along dashed lines on all four panels of carton. Remove end panels and lay side panels flat.

•Check for any additional loose parts or cartons and remove.

TO CHECK BATTERY (See Fig. 1)

•Lift seat to raised position.

NOTE: If this battery is put into service after month and year indicated on label (label is located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in Maintenance section of this manual for charging instructions).

•For battery and battery cable installation see "RE- PLACING BATTERY" in the "Service and Adjustments" section in this manual.

LABEL

FIG. 1

ADJUST SEAT (See Fig. 2)

•Sit in seat.

•Lift up adjustment lever (A) and slide seat until a com- fortable position is reached which allows you to press clutch/brake pedal all the way down.

•Release lever to lock seat in position.

A

FIG. 2

NOTE: You may now roll your tractor off the skid. Follow the instructions below to remove the tractor from the skid.

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)

•Raise attachment lift lever to its highest position.

•Release parking brake by depressing brake pedal.

•Place freewheel control in disengaged position to dis- engage transmission (See “TO TRANSPORT” in the Operation section of this manual).

•Roll tractor forward off skid.

Continue with the instructions that follow.

5

Image 5

Contents Owners Manual / 96045000408 YTH20K46Safe Operation Practices for Ride-On Mowers SAFETY RULESI. GENERAL OPERATION II. SLOPE OPERATIONIV. TOWING V. SERVICEIII. CHILDREN CUSTOMER RESPONSIBILITIES TABLE OF CONTENTSPRODUCT SPECIFICATIONS TO CHECK BATTERY See Fig ASSEMBLYADJUST SEAT See Fig UNASSEMBLED PARTSCHECK DECK LEVELNESS CHECK TIRE PRESSURECHECK FOR PROPER POSITION OF ALL BELTS CHECK BRAKE SYSTEMOPERATION PH DG E KNOW YOUR TRACTORTO SET PARKING BRAKE See Fig HOW TO USE YOUR TRACTORSTOPPING See Fig. 5A TO USE THROTTLE CONTROL D See Fig. BTO ADJUST GAUGE WHEELS See Fig TO ADJUST MOWER CUTTING HEIGHT See FigTO MOVE FORWARD AND BACKWARD See Fig TO USE CRUISE CONTROL J See FigREVERSE OPERATION SYSTEM ROS See Fig TO OPERATE MOWER See FigTO OPERATE ON HILLS TO TRANSPORT See Figs. 3 andBEFORE STARTING THE ENGINE SERVICE REMINDER/HOUR METERCHECK ENGINE OIL LEVEL ADD GASOLINEPURGE TRANSMISSION MOWING TIPSLUBRICATION CHART MAINTENANCETRACTOR BATTERYBLADE CARE BLADE REMOVAL See FigV-BELTS ENGINETRANSAXLE COOLING TRANSAXLE PUMP FLUIDCLEAN AIR INTAKE/COOLING AREAS CLEANINGCLEAN AIR SCREEN AIR FILTERTO INSTALL MOWER See Figs SERVICE AND ADJUSTMENTSTO REMOVE MOWER See Fig Q R AEE FJ H TO LEVEL MOWER TO REPLACE MOTION DRIVE BELT See Fig TO REPLACE MOWER BLADE DRIVE BELT See FigTO CHECK BRAKE TO START ENGINE WITH A WEAK BATTERY See Fig TO ADJUST STEERING WHEEL ALIGNMENTFRONT WHEEL TOE-IN/CAMBER TO REMOVE WHEEL FOR REPAIRS See FigTO REMOVE HOOD AND GRILL ASSEMBLY See Fig REPLACING BATTERY See FigTO ADJUST THROTTLE CONTROL CABLE TO ADJUST CARBURETOROTHER STORAGEFUEL SYSTEM ENGINE OILPROBLEM TROUBLESHOOTING POINTSCAUSE CORRECTIONEngine dies when TRACTOR - - MODEL NUMBER YTH20K46 96045000408, PRODUCT NO. 960 45 SCHEMATICIGNITION SWITCH SCH10With Service Minder Option ELECTRICALTRACTOR - - MODEL NUMBER YTH20K46 96045000408, PRODUCT NO. 960 45 T04SELECTRICAL CHASSIS CHASSIS drive-texT2pedal10 DRIVEDRIVE engine-texKohl7 ENGINESPARK ARRESTER KIT ENGINE steering-texLEGND216 STEERING ASSEMBLYTRACTOR - - MODEL NUMBER YTH20K46 96045000408, PRODUCT NO. 960 45 wheelart1-tex DECALSWHEELS AND TIRES seat-tex6.5SL3 SEAT ASSEMBLY46texltpred3r6 MOWER DECKMOWER DECK lift-tex6 MOWER LIFTHUSQVARNA PRODUCT REGISTRATION INFORMATION & WARRANTY STATEMENT SECTION 3 ITEMS NOT COVERED BY THIS WARRANTY SECTION 2 HUSQVARNAS OBLIGATIONS UNDER THE WARRANTYSECTION 6 PROCEDURE TO OBTAIN WARRANTY CONSIDERATION SECTION 4 EXCEPTIONS AND LIMITATIONSPrinted in the U.S.A 532 42 20-50R1 07.30.08 AP