Husqvarna 96045000408 Husqvarnas Obligations Under The Warranty, Exceptions And Limitations

Page 44

Refer to Section 3 for items not covered by this warranty

*All consumer product use must have been limited to the ownerSECTION 2: HUSQVARNAS OBLIGATIONS UNDER THE WARRANTYs residence. Warranted for noncommercial, nonprofessional, noninstitutional and nonincome producing use.

**HUV 2 Year or 2,000 Hour Powertrain (The engine assembly, unitized transaxle assembly (gasoline vehicle), motor, and main frame assembly are warranted with respect to parts and labor against defects in material and workmanship or a period of two years or 2000 hours of operation, whichever first occurs, from the date of purchase.) & 1 Year or 1,000 Hour Body Warranty (All remaining components of the vehicle not specified otherwise and all other original equipment options and accessories supplied by Husqvarna are warranted with respect to parts and labor against defects in material and workmanship for a period of one year or 1000 hours of operation, whichever first occurs, from the date of purchase.)

HUVSECTION 3: ITEMS NOT COVERED BY THIS WARRANTYs Gas & Diesel Powered Battery: 0 – 6 months free replacement and 7 – 12 months prorated

HUVSECTION 4: EXCEPTIONS AND LIMITATIONSs Electric Powered – 4 year or 16,000 Energy Unit Limited Warranty Period

***Husqvarna safety apparel warranty is from the date of the customerSECTION 5: CUSTOMER RESPONSIBILITIESs original purchase for defects in material and workmanship. Normal wear, tear or abuse is not covered under warranty. All care and maintenance instructions must be followed as stated by the manufacturer on the care label. The fit of the protective apparel/boot is not covered under warranty.

****Battery 1 Year prorated limited warranty with 100% replacement during the first 6 months.

Lifetime Warranty (Parts and Labor): All tiller tines and trimmer shafts against breakage. Proof of purchase required.

Lifetime Warranty (“PARTS ONLY” after initial warranty expiration): Ignition coils and modules on handheld product. Proof of purchase required.

SECTION 2: HUSQVARNASECTION 6: PROCEDURE TO OBTAIN WARRANTY CONSIDERATIONS OBLIGATIONS UNDER THE WARRANTY

Husqvarna will repair or replace defective components without charge for parts or labor if a component fails because of a defect in material or workmanship during the warranty period.

SECTION 3: ITEMS NOT COVERED BY THIS WARRANTY

The following items are not covered by this warranty:

(1)Normal customer maintenance items which become worn through normal regular use, including, but not limited to, belts, blades, blade adapters, bulbs, clutches, clutch drums, filters (fuel line, fuel filters, air filters, oil filters), sprockets, guide bars, lubricants, rewind springs, saw chain, spark plugs, starter ropes and tiller tines;

(2)Natural discoloration of material due to ultraviolet light;

(3)Engine and drive systems not manufactured by Husqvarna; these items are covered by the respective manufacturerHUSQVARNA 7349 Statesville Road, Charlotte, NC 28269s warranty as provided in writing with the product information supplied at the time of purchase; all claims must be sent to the appropriate manufacturer.

(4)Lawn and garden attachments that are covered by a third party which gives a warranty, all claims for warranty should be sent to the manufacturer.

(5)Commercial or consumer mowing decks with sand abrasion damage.

(6)Emission Control System components necessary to comply with CARB-TIER II and EPA regulations which are manufactured by third party engine manufacturer.

SECTION 4: EXCEPTIONS AND LIMITATIONS

This warranty shall be inapplicable to defects resulting from the following:

(1)Accident, abuse, misuse, negligence and neglect, including stale fuel, dirt, abrasives, moisture, rust, corrosion, or any adverse reaction due to incorrect storage or use habits;

(2)Failure to operate or maintain the unit in accordance with the OwnerPart Number 525 88 56-01s/OperatorManual backgrounds manual or instruction sheet furnished by Husqvarna;

(3)Alterations or modifications that change the intended use of the product or affects the productManual backgrounds performance, operation, safety, or durability, or causes the product to fail to comply with any applicable laws; or:

(4)Additional damage to parts or components due to continued use occurring after any of the above.

REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HUSQVARNA SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THESE PRODUCTS EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THESE PRODUCTS IS LIMITED IN DURATION TO THE WARRANTY PERIOD AS DEFINED IN THE LIMITED WARRANTY STATEMENT. HUSQVARNA RESERVES THE RIGHT TO CHANGE OR IMPROVE THE DESIGN OF THE PRODUCT WITHOUT NOTICE, AND DOES NOT ASSUME OBLIGATION TO UPDATE PREVIOUSLY MANUFACTURED PRODUCTS.

Some states do not allow the exclusion of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary by state.

SECTION 5: CUSTOMER RESPONSIBILITIES

The product must exhibit reasonable care, maintenance, operation, storage and general upkeep as written in the maintenance section of the OwnerManual backgrounds/OperatorManual backgrounds manual. Should an operational problem or failure occur, the product should not be used. Failure caused by continued use is not covered by warranty. Product should be delivered, at owners expense, as is, to an authorized Husqvarna Servicing Retailer for evaluation. Proof of purchase, as explained in section 6, rests solely with the customer.

SECTION 6: PROCEDURE TO OBTAIN WARRANTY CONSIDERATION

It is the OwnerManual backgrounds and RetailerManual backgrounds responsibility to make certain that the Warranty Registration Card is properly filled out and mailed to Husqvarna. This card should be mailed within ten (10) days from the date of purchase in order to confirm the warranty and to facilitate post-sale service. Proof of purchase must be presented to the authorized Husqvarna retailer in order to obtain warranty service. This proof must include date purchased, model number, serial number, and complete name and address of the selling retailer. To obtain the benefit of this warranty, the product believed to be defective must be delivered to an authorized Husqvarna retailer in a timely manner, no later than thirty

(30)days from date of the operational problem or failure. The product must be delivered at the ownerManual backgrounds expense. Downtime, pick-up and delivery charges are not covered by this warranty. An authorized Husqvarna retailer can be located by calling 1-800-HUSKY-62 or visiting www.husqvarna.com

Subject to change without notice.

IR

HUSQVARNA 7349 Statesville Road, Charlotte, NC 28269

Part Number 525 88 56-01

 

Image 44
Contents YTH20K46 Owners Manual / 96045000408SAFETY RULES Safe Operation Practices for Ride-On MowersI. GENERAL OPERATION II. SLOPE OPERATIONIV. TOWING V. SERVICEIII. CHILDREN CUSTOMER RESPONSIBILITIES TABLE OF CONTENTSPRODUCT SPECIFICATIONS ASSEMBLY TO CHECK BATTERY See FigADJUST SEAT See Fig UNASSEMBLED PARTSCHECK TIRE PRESSURE CHECK DECK LEVELNESSCHECK FOR PROPER POSITION OF ALL BELTS CHECK BRAKE SYSTEMOPERATION KNOW YOUR TRACTOR PH DG EHOW TO USE YOUR TRACTOR TO SET PARKING BRAKE See FigSTOPPING See Fig. 5A TO USE THROTTLE CONTROL D See Fig. BTO ADJUST MOWER CUTTING HEIGHT See Fig TO ADJUST GAUGE WHEELS See FigTO MOVE FORWARD AND BACKWARD See Fig TO USE CRUISE CONTROL J See FigTO OPERATE MOWER See Fig REVERSE OPERATION SYSTEM ROS See FigTO OPERATE ON HILLS TO TRANSPORT See Figs. 3 andSERVICE REMINDER/HOUR METER BEFORE STARTING THE ENGINECHECK ENGINE OIL LEVEL ADD GASOLINEMOWING TIPS PURGE TRANSMISSIONMAINTENANCE LUBRICATION CHARTBATTERY TRACTORBLADE CARE BLADE REMOVAL See FigENGINE V-BELTSTRANSAXLE COOLING TRANSAXLE PUMP FLUIDCLEANING CLEAN AIR INTAKE/COOLING AREASCLEAN AIR SCREEN AIR FILTERSERVICE AND ADJUSTMENTS TO INSTALL MOWER See FigsTO REMOVE MOWER See Fig Q R AEE FJ H TO LEVEL MOWER TO REPLACE MOTION DRIVE BELT See Fig TO REPLACE MOWER BLADE DRIVE BELT See FigTO CHECK BRAKE TO ADJUST STEERING WHEEL ALIGNMENT TO START ENGINE WITH A WEAK BATTERY See FigFRONT WHEEL TOE-IN/CAMBER TO REMOVE WHEEL FOR REPAIRS See FigREPLACING BATTERY See Fig TO REMOVE HOOD AND GRILL ASSEMBLY See FigTO ADJUST THROTTLE CONTROL CABLE TO ADJUST CARBURETORSTORAGE OTHERFUEL SYSTEM ENGINE OILTROUBLESHOOTING POINTS PROBLEMCAUSE CORRECTIONEngine dies when SCHEMATIC TRACTOR - - MODEL NUMBER YTH20K46 96045000408, PRODUCT NO. 960 45IGNITION SWITCH SCH10ELECTRICAL With Service Minder OptionTRACTOR - - MODEL NUMBER YTH20K46 96045000408, PRODUCT NO. 960 45 T04STRACTOR - - MODEL NUMBER YTH20K46 96045000408, PRODUCT NO. 960 45 CHASSIS TRACTOR - - MODEL NUMBER YTH20K46 96045000408, PRODUCT NO. 960 45 DRIVE drive-texT2pedal10DRIVE engine-texKohl7 ENGINESPARK ARRESTER KIT TRACTOR - - MODEL NUMBER YTH20K46 96045000408, PRODUCT NO. 960 45 STEERING ASSEMBLY steering-texLEGND216STEERING ASSEMBLY wheelart1-tex DECALSWHEELS AND TIRES SEAT ASSEMBLY seat-tex6.5SL3MOWER DECK 46texltpred3r6TRACTOR - - MODEL NUMBER YTH20K46 96045000408, PRODUCT NO. 960 45 MOWER LIFT lift-tex6HUSQVARNA PRODUCT REGISTRATION INFORMATION & WARRANTY STATEMENT SECTION 2 HUSQVARNAS OBLIGATIONS UNDER THE WARRANTY SECTION 3 ITEMS NOT COVERED BY THIS WARRANTYSECTION 6 PROCEDURE TO OBTAIN WARRANTY CONSIDERATION SECTION 4 EXCEPTIONS AND LIMITATIONS532 42 20-50R1 07.30.08 AP Printed in the U.S.A