Husqvarna 917.27909 Transmission REMOVAL/REPLACEMENT, To Adjust Steering Wheel ALIGN- Ment

Page 24

SERVICE AND ADJUSTMENTS

TRACTORV-BELTDRIVE SCHEMATIC

VIEWED FROM L.H. SIDE OFTRACTOR

CLUTCHING

IDLER

"_NGINEBELT

CLUTCHING

FLAT IDLER

V-IDLERABOVE MIDSPAN

BELT KEEPER

KEEPER

BELT

 

 

TWISTS

 

ENGINE

BELT

TRANSAXLE

KEEPER

PULLEY

PULLEY

 

 

V-IDLER

AS VIEWED FROM BOTTOM

FIG. 26

TRANSMISSION REMOVAL/REPLACEMENT

Should your transmission require removal for service or replacement, it should be purged after reinstallation and before operating the tractor, See"PURGETRANSMISSION" in the Operation section of this manual.

TO ADJUST STEERING WHEEL ALIGN- MENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straightforward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual,

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS

FRONT WHEEL (See Fig. 27)

Block up axle securely.

Remove axle cover, retaining ring and washers to allow wheel removal.

Repair tire and reassemble,

Replace washers and snap retaining ring securely in axle groove,

Replace axle cover.

REAR WHEEL -

Block rear axle securely,

Remove five (5) hub bolts to allow wheel removal,

Repair tire and reassemble. Replace and tighten hub bolts securely,

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer, Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE

COVER

,Q

FIG. 27

TO START ENGINE WITH A WEAK BATTERY (See Fig. 28)

&WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoki ng materials away from

batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the Maintenance section of this manual).

If "jumper cables" are used for emergency starting, follow this procedure:

IMPORTANT:YOURTRACTORIS EQUIPPEDWITH A 12VOLT SYSTEM.THE OTHER VEHICLE MUST ALSO BE A 12 VOLT

SYSTEM.DO NOTUSEYOURTRACTORBATTERYTO START OTHERVEHICLES.

TO ATTACH JUMPER CABLES -

Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis,

Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery,

Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

BLACK cable first from chassis and then from the fully charged battery.

RED cable last from both batteries.

DD

 

02614

WEAK OR DEAD

FULLY CHARGED

BATTERY

BATTERY

 

FIG. 28

24

Image 24
Contents Husqvarna Safe Operation Practices for Ride-On Mowers General OperationII. Slope Operation Service Safe Operation PracticesIII. Children IV. Towi NGContents Unassembled Parts Tools Required for Assembly CartonBefore Removing Tractor from Skid Unpack CartonInstall Seat See Fig Assemble Gauge Wheels to Mower Deck SeeInstall Mower and Drive Belt Sees Engage slowlyChecklist Checktire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation LOW Choke FastKnow Your Tractor HOW to USE Your Tractor To Adjust Gauge Wheels See Fig Using the Reverse Operation SystemTo Operate Mower See Fig Reverse Operation System ROSBefore Starting the Engine To Operate on HillsTowing Carts and Other Attach Ments Check Engine OIL LevelMowing Tips Maintenance Lubrication ChartGeneral Recommendations Before Each USETractor Blade Removal See FigTo Sharpen Blade See Fig Battery EngineBelts Transaxle CoolingCleaning Service and Adjustments To Install MowerTo Level Mower Housing To Remove Mower See FigService AdjustmentsMower Drive Belt Installation To Replace Mower Drive BeltMower Drive Belt Removal Belt RoutingTo Check and Adjust Brake To Adjust Attachment Clutch With Parkingbrake EngagedTo Replace Motion Drive Belt Transmission REMOVAL/REPLACEMENT To Adjust Steering Wheel ALIGN- MentTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbFuel System Engine OILCylinders Points Cause CorrectionProblem Cause Correction EngagedSchematic Solenoid Optional Fuel LineElectrical KEY Part Description Chassis and Enclosures Repair Parts Ground Drive Repair Parts Steering Assembly Repair Parts Engine Spark Arrester KITKEY PartSeat Assembly KEY Part DescriptionDecals KEYPart KEY Description Lift Assembly 11/32 x 1-1/2 x 10 Ga Mower Deck 183 Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXWarranty Statement HusqvarnaHusqvarna

917.27909 specifications

The Husqvarna 917.27909 is a formidable riding lawn mower, designed to offer both power and versatility for homeowners who prioritize efficiency in lawn care. With a robust construction and user-friendly features, this model has garnered attention for its ability to tackle various landscaping tasks.

One of the standout features of the Husqvarna 917.27909 is its powerful engine. Equipped with a 24 horsepower Briggs & Stratton engine, it delivers reliable performance that can handle larger mowing areas without faltering. This engine offers a combination of durability and smooth operation, ensuring that even challenging terrains can be managed with ease.

The cutting deck of the Husqvarna 917.27909 measures 48 inches, allowing for an impressive cutting swath. This wide deck reduces mowing time, making it efficient for expansive yards. The deck is made of high-quality materials that resist wear and tear, and it features an adjustable cutting height to cater to varying grass lengths and user preferences.

An innovative aspect of this mower is its cutting system. The model incorporates a three-blade system that ensures a clean and even cut. This is particularly beneficial for maintaining a healthy lawn, as it prevents grass from being torn and provides a polished finish to the landscape.

User comfort is another key characteristic of the Husqvarna 917.27909. The mower is designed with an ergonomic seat and convenient controls that place essential functions at the operator's fingertips. Additionally, the steering wheel is designed for ease of use, enabling smooth maneuverability around trees and flower beds.

Technologically, the Husqvarna 917.27909 features a hydrostatic transmission, which allows for seamless speed adjustments without the need for manual gear changes. This technology enhances the overall mowing experience by providing intuitive control and the ability to navigate effortlessly across different surfaces.

For maintenance, the model includes practical features such as an easy-access deck wash port. This allows users to connect their garden hose for quick cleaning of the mowing deck, reducing the time spent on upkeep.

In summary, the Husqvarna 917.27909 is a well-engineered riding lawn mower that marries power and convenience. With its strong engine, efficient cutting deck, comfortable user experience, and innovative technology, it stands as a reliable choice for anyone looking to maintain their lawn with minimal effort and maximum results.