Husqvarna 917.27909 owner manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 25

SERVICE AND

REPLACING BATTERY (See Fig. 29)

&WARNING: Do not short battery ter- minals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected fi rst to prevent sparking from accidental grounding.

•Lift hood to raised position,

•Remove terminal guard.

•Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor,

•Install new battery with terminals in same position as old battery.

•Reinstall terminal guard,

•First connect RED battery cable to positive (+) battery terminal with hex bolt and keps nut as shown, Tighten securely.

•Connect BLACK grounding cable to negative (-) battery terminal with remaining hex bolt and keps nut,Tighten securely

•Close terminal access doors.

•Close hood.

 

KEPS NUT

ACCESS

HEX BOLT

TERMINAL

.._.,

DOOR _

 

POSITIVE

 

CABLE

TERMINAL

 

GUARD

 

 

(BLACK)

 

CABLE

 

FIG. 29

TO REPLACE HEADLIGHT BULB

•Raise hood,

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill,

•Close hood,

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting,

•Check wiring, See electrical wiring diagram in the Repair Parts section.

ADJUSTMENTS

TO REPLACE FUSE

Replace with 30 amp automotive-type plug-in fuse. The fuse holder is located behind the dash,

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 30)

•Raise hood,

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor,

•To replace, reverse above procedures,

HOOD

HEADLIGHT

WIRE

CONNECTOR

FIG. 30

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is necessary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and ad- justment should not be necessary, If adjustment is neces- sary, see engine manual,

TO ADJUST CARBURETOR

Your carburetor is not adjustable, If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Husqvarna General Operation Safe Operation Practices for Ride-On MowersII. Slope Operation Safe Operation Practices ServiceIII. Children IV. Towi NGContents Unassembled Parts Carton Tools Required for AssemblyBefore Removing Tractor from Skid Unpack CartonAssemble Gauge Wheels to Mower Deck See Install Seat See FigEngage slowly Install Mower and Drive Belt SeesChecktire Pressure ChecklistCheck Deck Levelness Check for Proper Position of ALL BeltsLOW Choke Fast OperationKnow Your Tractor HOW to USE Your Tractor Using the Reverse Operation System To Adjust Gauge Wheels See FigTo Operate Mower See Fig Reverse Operation System ROSTo Operate on Hills Before Starting the EngineTowing Carts and Other Attach Ments Check Engine OIL LevelMowing Tips Lubrication Chart MaintenanceGeneral Recommendations Before Each USEBlade Removal See Fig TractorTo Sharpen Blade See Fig Engine BatteryBelts Transaxle CoolingCleaning To Install Mower Service and AdjustmentsTo Level Mower Housing To Remove Mower See FigAdjustments ServiceTo Replace Mower Drive Belt Mower Drive Belt InstallationMower Drive Belt Removal Belt RoutingTo Adjust Attachment Clutch With Parkingbrake Engaged To Check and Adjust BrakeTo Replace Motion Drive Belt To Adjust Steering Wheel ALIGN- Ment Transmission REMOVAL/REPLACEMENTTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbEngine OIL Fuel SystemCylinders Cause Correction PointsEngaged Problem Cause CorrectionSolenoid Optional Fuel Line SchematicElectrical KEY Part Description Chassis and Enclosures Repair Parts Ground Drive Repair Parts Steering Assembly Repair Parts Spark Arrester KIT EnginePart KEYKEY Part Description Seat AssemblyKEY DecalsPart KEY Description Lift Assembly 11/32 x 1-1/2 x 10 Ga Mower Deck 183 Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationHusqvarna Warranty StatementHusqvarna

917.27909 specifications

The Husqvarna 917.27909 is a formidable riding lawn mower, designed to offer both power and versatility for homeowners who prioritize efficiency in lawn care. With a robust construction and user-friendly features, this model has garnered attention for its ability to tackle various landscaping tasks.

One of the standout features of the Husqvarna 917.27909 is its powerful engine. Equipped with a 24 horsepower Briggs & Stratton engine, it delivers reliable performance that can handle larger mowing areas without faltering. This engine offers a combination of durability and smooth operation, ensuring that even challenging terrains can be managed with ease.

The cutting deck of the Husqvarna 917.27909 measures 48 inches, allowing for an impressive cutting swath. This wide deck reduces mowing time, making it efficient for expansive yards. The deck is made of high-quality materials that resist wear and tear, and it features an adjustable cutting height to cater to varying grass lengths and user preferences.

An innovative aspect of this mower is its cutting system. The model incorporates a three-blade system that ensures a clean and even cut. This is particularly beneficial for maintaining a healthy lawn, as it prevents grass from being torn and provides a polished finish to the landscape.

User comfort is another key characteristic of the Husqvarna 917.27909. The mower is designed with an ergonomic seat and convenient controls that place essential functions at the operator's fingertips. Additionally, the steering wheel is designed for ease of use, enabling smooth maneuverability around trees and flower beds.

Technologically, the Husqvarna 917.27909 features a hydrostatic transmission, which allows for seamless speed adjustments without the need for manual gear changes. This technology enhances the overall mowing experience by providing intuitive control and the ability to navigate effortlessly across different surfaces.

For maintenance, the model includes practical features such as an easy-access deck wash port. This allows users to connect their garden hose for quick cleaning of the mowing deck, reducing the time spent on upkeep.

In summary, the Husqvarna 917.27909 is a well-engineered riding lawn mower that marries power and convenience. With its strong engine, efficient cutting deck, comfortable user experience, and innovative technology, it stands as a reliable choice for anyone looking to maintain their lawn with minimal effort and maximum results.
Top Page Image Contents